Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Shelix jointer head

Posts

Shelix jointer head

#1

Shelix jointer head

David W

>I finally bit the bulllet and bought a Shelix head for my Grizzly 8" jointer. I was surprised to see the cost on the Grizzly site was $100 less than the price for the same unit on the Byrd site. I bought it from Grizzly. It was more of a PITA to install than I was expecting. Getting the ball bearing fittings off without the correct tools was frustrating. I ended up using wooden wedges to get them off wihtout damage. It was also difficult getting the pulley on the new head as the hole was about 1/64th" too small. I will say the cut is amazing, but I don't think I will be trying this with my 15" Delta planer.

Re: Shelix jointer head

#2

Re: Shelix jointer head

Roger

>Go ahead and try it on your 15" Delta Planer. I installed the shelix head on my Delta DC380 and if you follow the instructions posted on the Byrd site, it is fairly easy and straight forward, plus it is very rewarding with noise reduction and paining quality.

Roger