Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Refinishing problem

Posts

Refinishing problem

#1

Refinishing problem

Ed Freestone

>I removed the polyurethane from a table top with SoyGel stripper. I rinsed the top with clear water and dried with terry towels. After a couple days I sanded the raised grain but the sandpaper kept clogging very quickly - every 3-5 strokes. I rinsed several more times and let the top dry completely. The sandpaper still clogs, though not as badly.

Could there be stripper residue in the pores of the wood? Will this inhibit the bonding and curing of my new finish? I will be using General Finishes gel stain and Arm-R-Seal.

Thanks,

Ed Freestone.

Re: Refinishing problem

#2

JL

Re: Refinishing problem

JL

>As you surmised, you may have a lot of residual finish left on the top.

I didn't see anything about scraping the top after the application of the stripper in your post.

I usually scrape the piece with a drywall knife for the flat areas and smaller scrapers for the other areas before I rinse. I then may tackle it with a soft brush or a nylon dish scrubber (something I can rinse out in a bucket). Then I rinse with water and towels.

You can try another application of your stripper and use a soft brush or a drywall knife. Another thought is to just try something like a card scraper right now.

My $0.02.

Re: Refinishing problem

#3

Re: Refinishing problem

Dick Coers

>Does there appear to be a film on the wood yet? I would suggest a cleaning with lacquer thinner and a scotch-brite pad. Might just be some wax from the stripper. I'm not familar with the stripper you used, but some strippers add a wax to slow the evaporating of the solvents from the stripper so it can do it's job.

The universal sealer used by a lot of refinishers to seal in any contaminats is shellac. Might want to think about using that before the general finish.

Re: Refinishing problem

#4

Re: Refinishing problem

Ed Freestone

>Thanks, JL. I did use a wide drywall knife and a plastic scraper to remove the stripper and finish. Then I used clean sponge and water. For subsequent rinses I used a synthetic sheepskin and terry towels. At this point I have also rinsed with mineral spirits.

Ed.

Re: Refinishing problem

#5

Re: Refinishing problem

Ed Freestone

>Thanks, Dick. There is no surface film that I can detect and no odor. Will sealing with shellac still allow the gel stain?

Ed.

Re: Refinishing problem

#6

JL

Re: Refinishing problem

JL

>You've let it dry out for a few days and still have the problem?

I've experienced similar sanding "problems" while stripping. If it needs to be done quickly, I usually start with a card scraper and scrape it first. I then clean it up with 80 grit and work up from there.

You've softened the wood fibers a lot with the application of the soy stripper and lots of water.

A couple of thoughts - rinse with denatured alcohol and let dry. This will draw the water out better then mineral spirits.

You can try Dick's suggestion of a light cut of shellac to seal. Your gel stain ought to work with that. I would try a test board first though. Your stain isn't going to penetrate as much with a 1 lb cut.