Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Curved Headboard Panel Question

Posts

Curved Headboard Panel Question

#1

Curved Headboard Panel Question

Mac in Indy

>I'm trying to build a bed that has a curved, Sleigh-like headboard. It is inspired by a Thomas Moser design but with less curve to it due to overall length restraints of our bedroom. I have the bed all designed out except for that panel.

I was originally going to take four 4" wide 4/4 boards and joint them with a small angle and glue up a segmentally "curved" panel. It would then need to be smoothed using planes scrapers and sanders along with templates to determine when the curve is right.

Option 2: Use bending plywood as layers of a laminated glueup that would have home cut cherry veneer on either side. This will require bending forms but I don't mind that. I've never used bending plywood so anyone have a clue how much springback to expect? It's bending about 11 degrees across 16-17 inches.

Thanks,

Mac

Re: Curved Headboard Panel Question

#2

Something like this? *LINK*

Dave Smith, Longview, WA

>Hi Mac,

I used two pieces of 3/8" bending plywood. Once glued together the panel is quite ridged. I don't know if I have any pictures of construction.

Good luck.

Dave Smith

Still kicking in Longview, WA.


White oak sleigh bed

Re: Curved Headboard Panel Question

#3

Yes

Mac in Indy

>That's the idea. Mine will be a single curve.

How did you connect the curved panel to the legs?

Mac