Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Will this work?

Posts

Will this work?

#1

Will this work?

Bill Timmons

>Good morning,

California's a community property state so I'm only "allowed" to us half of our two-car garage for a new woodshop. I want to switch out our aluminum overhead door for two wooden sliding doors. This creates a lot of usable space on the overhead. Yes, I was in the Navy. (-:

Here's my question:

I want to take my garage door opener, which has a worm-drive gear, and ceiling mount it on the shop side, adjacent and perpendicular to the doors. It would be attached to the far door and would either push or pull to open and close the far sliding door.

Am I clear on the concept? Do problems I don't see leap out at you?

Thanks for any input.

Bill Timmons

Sacramento, CA

Re: Will this work?

#2

Re: Will this work?

Lee Schierer - McKean, PA

>You have to have a place for the door to slide to. If the track for the door is outside and the opener is inside, the connection between them may be a problem. The attachement point of the opener to the door may prevent it from opening all the way.

Be careful putting too much weight in the overhead or it may land on your head and I don't mean the bathroom! Wood trusses are generally not rated for carrying a load on their bottom member and may fail putting your opver head on your deck. I was in the Navy too! ;)

Lee

Re: Will this work?

#3

Re: Will this work?

GalenV

>I am not sure if you are talking about a patio door that the weight is carried on bottom rollers and track or barn type door that runs on track and rollers hung from the top.

It may make a difference in where you attach the push/pull points and not dog leg the door.

If you say the worm may mount perpendicular to the doors on the wall, are you thinking pulleys and cable to turn the motion 90 degree? You would also need it to set up to pull and push so cable and pulleys gets more complicated, unless the patio doors have self closure feature. Depending on the force needed to push or pull the door your worm drive opener may torque out as the normal vertical door is assisted by springs. I assume the patio type doors would not have the travel the worm can produce so can the limit switches be set for say half the travel?

Seems like if the door was hung from the top and the worm mounted parallel and at top the carrier could be attached to give you the push /pull in a lot easier manor.

May be too many thoughts. Just what went through my head and out my fingers.

Confussed?

Galen

Re: Will this work?

#4

Re: Will this work?

mdclor

>How about an airplane hanger type door that is hinged in the center horizontally? It is opened by a cable that pulls the bottom upward on the outside rather than the inside.

Re: Will this work?

#5

Re: Will this work?

Fred Davis

>Yes and Yes and Yes

FredD