Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Jessem Mastr Slider

Posts

Jessem Mastr Slider

#1

Jessem Mastr Slider

howard

>Bought it 1 year ago to mount on Delta Contractor saw. Never did. Contractor saw broke on move to new shop. Bought new PM2000. Slider won't fit, fence rails are in the way. Anybody want a never used one for $300+ship, or any ideas on how to make it work. Thanks

Re: Jessem Mastr Slider

#2

Re: Jessem Mastr Slider

Howard Norman

>I am not familiar with your particular saw but I would suggest you look to see if you can't cut the fence rails to accommodate the Jessem.

Re: Jessem Mastr Slider

#3

Cut to be able to re-join *LINK*

Garrett in Victoria

>Hi Howard

If you read my article at the link below, there's a section on cutting the Unifence rail in a way that you can later re-join it. I see no reason why you couldn't do the same for your PM.

Cheers, Garrett


Cutting the rails and re-joining them later

Re: Jessem Mastr Slider

#4

Drill new holes in the fence guide rails?

Ray Newman

>One time I had an Excaliber (or an Exaktor??) sliding table mounted on my Uni-saw. The directions advised to cut the guide rails.

Instead of cutting the guide rails, I simply drilled two additional holes to shift the fence to the right, then install the sliding table. When I removed the table, I moved the fence rail to its original position by utilizing the original holes.

This seemed to me to be a much neater & easier way to mount the sliding table than by cutting off 8-10" of the fence

guide rails

Re: Jessem Mastr Slider

#5

Thanks for the advice.......

howard

>I will try first moving the fence rails over to avoid cutting them. If that doesn't do it for me, then I will likely use a sled. Thanks again.