Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Woodcraft Lumber Storage System *LINK*

Posts

Woodcraft Lumber Storage System *LINK*

#1

Woodcraft Lumber Storage System *LINK*

Steven Bellner

>Has anyone used this system? I have a lot of very old barnwood I have had stickered, and I would like to get the pieces sorted so I can start using them. This system looks pretty flexible and very sturdy. It's a bit pricey, but if you look at piecing together a heavy-duty "shelving system" from one of the big boxes, once you get all the pieces you need the price difference isn't too great.

Is there a problem with storing dry wood on metal brackets? The wood is dry, but it isn't bone-dry. The lumber rack is galvanized. I'm wondering if the wood needs to be protected from the metal.


Heavy-duty lumber storage rack

Re: Woodcraft Lumber Storage System *LINK*

#2

Bart Goldberg

Re: Woodcraft Lumber Storage System

Bart Goldberg

>Hi Steve,

Yes, I have this rack system installed in my garage. It is incredibly strong and will be fine for what you intend to use if for. I would not be overly concerned about the moisture issue, but if you are concerned, just wrap some plastic wrap around the supports.

Regards

Bart

Re: Woodcraft Lumber Storage System *LINK*

#3

Re: Woodcraft Lumber Storage System

John K Jordan

>Steven,

Just an observation, but if the old barnwood you have is out of the weather and air dried to equilibrium, there is no need to sticker it. However, if you move it indoors to a conditioned space which on average is drier than the outside, it must be stickered then if you want it to reach the "inside" equilibrium. I suspect you know all about this but just in case...

JKJ

Re: Woodcraft Lumber Storage System *LINK*

#4

Re: Woodcraft Lumber Storage System

Steven Bellner

>This stuff has been outside for over a hundred years. We tore down a friend of mine's tobacco barn a couple of years ago, and he was planning on just burning the wood. A lot of the wood was in pretty bad shape, as it obviously had some ground contact at one point. Some of it may still be no good, but I'm sure there are some gems in there.

I had stacked the wood outside, and it took me a couple of months to break it down, and take out all the (obvious) nails. Since it had been outside for so long, and not covered, I brought it into the basement and stickered it for a year. Now it's time to see what I have, but it's in a pretty unmanagable pile. I'm looking to put up some heavy-duty lumber storage racks and sort as I go. I have needed a decent rack for a while, and this is a good excuse to go out and get one. I went out to Woodcraft and looked at this one. It looks like the wall would fail before this rack would break.

I was very disapppointed with the shelving supports at the home centers. There used to be some decent heavy-duty generic adjustable supports available, but now they are all "designer" hanging brackets, that don't look like the could hold towels, let alone wood.

Re: Woodcraft Lumber Storage System *LINK*

#5

Re: Woodcraft Lumber Storage System

John K Jordan

>I agree with you on the state of available shelving racks. I also hate to pay what I think are often outrageous prices for "lumber" racks. (I haven't looked at the one you mentioned.)

What I did when I need to rack steel stock was weld up my own brackets from square tubing. I butt-welded lengths of tubing to pieces of heavy angle iron and welded a short 45deg support underneath from the horizontal to the angle iron. The angle iron allowed me to fasten the supports with lag screws to both the front and sides of wooden beams or studs. This was very strong and easily supported many hundreds of pounds per pair. I haven't built a set yet for lumber but that's the route I intend to go when the time is right. However, these brackets are not adjustable unless you count moving the screws!

If you don't have a welder, this would be a good excuse to get a (cheap) flux-core wire welder. They are about as easy to use as a pencil.

JKJ

Re: Woodcraft Lumber Storage System *LINK*

#6

I have this system in use now......

Scott in Eastern Iowa

>.....you wont be disappointed in the amount you can stack on it, it literally holds a ton.......Ive got at least that on there now.

You may find that the arms vary from one dimension to its neighbor however. Mine varied over 5-6 spaces anywhere from 1/8" to 1/4" and they all started at the same floor elevation. Im not sure if my floors off that much or that quality control of the spacing standards is off, but something was amiss. I ended up shimming several of them so I wouldnt have warped boards.

All in all its a bit pricey, but I wanted the best and this was it. I would buy it all over again if need be...and regarding your worry over the metal staining the wood.....slip some pvc over them and your good to go....though I will say you likely wont need it.

Re: Woodcraft Lumber Storage System *LINK*

#7

Re: Woodcraft Lumber Storage System

Forrest Addy

>There's heavy duty thewn there is heavy duty. The rack unit in the link is heavy duty. It's a but a step up from a home center book shelf system. Don't get me wrong it will make a good lumber storage. I'm just ranting about product label inflation. Liek "6 HP vaccuum cleaners" and anything that Billy Mays sells. An honestly lableled heavy duty lumbeer rack will take a ton or so at each level. There's aisle of them at the BORG.

OK OK. Use that rack for your lumber. It will work great in your home shop. But don't stack too many boards on each level. There's That's not a sneer at their strength because they are pretty strong. I suggest you puy not over a half dozen boards or so per level. Lots of levels and few boards per level makes your storage easy to sort through to find just the right board for the coming project.

By the way: how much is a "lot?" A tight stack about 3 ft x 10 ft x 3 ft high is roughly a thousand bf. (Mbf). That would be a lot for a home shop.

Re: Woodcraft Lumber Storage System *LINK*

#8

Re: Woodcraft Lumber Storage System *LINK*

John Packett

>I looked at the one you are interested in but went with this one http://www.woodcraft.com/family.aspx?FamilyID=20063

I got mine at Woodcraft but they are avaible at Ace and other local hardware stores.

JEP


ANOTHER RACK OPTION

Re: Woodcraft Lumber Storage System *LINK*

#9

Re: Woodcraft Lumber Storage System

Fred Davis

>It's hard to believe that a woodworker with a shop full of tools and access to hardwood can't make a superior shelf support system.

FredD

http://picasaweb.google.com/FredD17209/shelf brackets

Re: Woodcraft Lumber Storage System *LINK*

#10

Re: Woodcraft Lumber Storage System

Fred Davis

>even leaving off the "shelf brackets" doesn't work , nevertheless this is what Picasa says to use for anybody wishing to view pics.

http://picasaweb.google.com/FredD17209

Lots of luck

FredD

Re: Woodcraft Lumber Storage System *LINK*

#11

Re: Woodcraft Lumber Storage System 

Fred Davis

>


img

Re: Woodcraft Lumber Storage System *LINK*

#12

Re: Woodcraft Lumber Storage System

Fred Davis

>wrong pic, this is supposed to be pics of shelf brackets one can make

FredD

Re: Woodcraft Lumber Storage System *LINK*

#13

Re: Woodcraft Lumber Storage System 

Fred Davis

>


img

Re: Woodcraft Lumber Storage System *LINK*

#14

Re: Woodcraft Lumber Storage System 

Fred Davis

>


img

Re: Woodcraft Lumber Storage System *LINK*

#15

Re: Woodcraft Lumber Storage System

Fred Davis

>last one

FredD


img