Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Cold Weather Finishing

Posts

Cold Weather Finishing

#1

Cold Weather Finishing

Bill Tindall, E.TN

>I spray all that I can which means finishing outside and letting solvent evaporate outside. So what to do when it is cold? Well it is not very cold yet but too cold to cure varnish in a short time.

These are the trunk parts, stained with Minwax Golden Oak, as recommended by WoodCentral, and then sprayed with Benjamine Moore alkyd varnish. After applying the finish I set the piece in some vehicle, in this case the Explorer, to cure. We are far enough south that the sun works and even in December it heats a car interior to toasty warmth. With the widows up, the sun made the interior more than 30 degrees above the outside temperature. The varnish was dust free in less than an hour and the finish was firm enough to move the piece in less than 6 hours.

With lacquer or conversion varnish the finish is dust free in minutes and cured in an hour or two. Later in the year I would heat the finish to room temperature and more important, have the wood toasty warm before spraying. I have done lacquer in the dead of our winter (equivalent to late July in MN).

In this case I used varnish and will rub out and wax tomorrow. This trunk will be a toy chest and get used. I thought the varnish would be durable and more easily repaired than conversion varnish or urethane. This particular varnish makes a bright finish that rubs out well. The inside is finished with shellac and rubbed out.

Re: Cold Weather Finishing

#3

Re: Cold Weather Finishing

Clint Searl, at the base of Haycock Mtn

>But doesn't the overspray kinda glaze up the interior of the Explorer????

Clint

Re: Cold Weather Finishing

#4

Re: Cold Weather Finishing

john l. blue

>interestin', I keep my chainsaws in my ol' f-100. Rain, sleet,

snow, hail, wind, dust, saws appreciate it. Blue

Re: Cold Weather Finishing

#5

Re: Cold Weather Finishing

Stuart Hough

>Bill, doesn't that give off some form of vapor that stays in the upholstery and on the inside of the glass? I would think the smell would be pretty strong for a time afterwards, not to mention hard to clean the residue off the glass.

Re: Cold Weather Finishing

#6

not a problem

Bill Tindall, E.TN

>I hope you didn't miss the sentence about putting in the vehicle AFTER spraying. The only vapors given off during cure will not condense on the windows. The inside smells like solvent for a few hours which does not bother me. The situation is no different than applying hair spray (nitrocellulose lacquer with perfume), painting trim or varnishing a floor indoors. Now a car someone has smoked in...that bothers me.

Re: Cold Weather Finishing

#7

Ellis Walentine

Variations on the outdoor theme

Ellis Walentine

>For many years, I had to be able to spray lacquer year-round, and I didn't have a spray booth for most of that time either. I had a heated garage connected to my shop and I would keep the finishing materials and the pieces to be finished inside the garage, at room temperature or above. Outside the big garage door, I had my horses or turntable or whatever holding fixture I needed for spraying. Even in 0° temperatures, I could quickly raise the garage door, shoot the piece, and then bring it back into the shop to dry. Worked like a charm. Most times, I got a good enough final finish right off the gun.

Ah reminiscences.

Ellis

Re: Cold Weather Finishing

#8

Re: Variations on the outdoor theme

Fred Davis

>no bugs either

FredD

Re: Cold Weather Finishing

#9

Switch to Deft

Lee Schierer - McKean, PA

>You can spray Deft Clear Wood Finish at very cold temps and it will cure just fine it takes longer, but the finish comes out the same. I use the brushable Deft and have applied it for years in the winter in an unheated building. You can do one coat every 24 hours.

Lee