Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Finishing question on QS Sycamore...

Posts

Finishing question on QS Sycamore...

#1

Finishing question on QS Sycamore...

Kris Lasure

>I'm wanting to pop the rays in the QS sycamore and the wife and I are after a mahogany color. I have tried samples and what we like best is this: 2 coats of Zinsser dewaxed shellac, Miwax stain (color escapes me at this time) and then 3 coats wipe on poly.

The reason for the shellac is that without it the stain seems to muddy up the grain and I get really dark areas between the rays. One coat of shellac does a decent job, but after two coats and then applying the stain looks pretty decent.

I have plenty of dye lying around so I could go that route for coloring purposes.

My main question is do any of you see issues with the stain over the shellac bonding properly? Would I be better off tinting the shellac?

Any other recipes out there for QS sycamore?

Thanks

kl

Re: Finishing question on QS Sycamore...

#2

Re: Finishing question on QS Sycamore...

George@Colonel's Workshop-Havertown PA

>Good Morning Kris,

I dunno. Any time I have tried to apply coloration via penetrating oil stain over two coats of Seal Coat, I find the surface sealed effectively. A gel stain may be an answer, but I've had mediocre success using that over truely sealed surfaces.

You say you have dye on hand. You didn't indicate if you had used it as a sample. I would use aniline dye over unsealed sycamore, having raised the wood grain first. Then use the Seal Coat followed by poly, or just the poly over the aniline dye.

George

Re: Finishing question on QS Sycamore...

#3

Re: Finishing question on QS Sycamore...

Kris Lasure

>Hi George -

I tend to agree. When I did the test samples with 2 coats of shellac, I had to very careful as the stain wanted to wipe away. So it was tedious to get an even color.

I think I'm going the dye route.

I'll have to post some pics when completed.

kl

Re: Finishing question on QS Sycamore...

#4

Re: Finishing question on QS Sycamore...

Jim Dillon

>Kris,

I have been experimenting with the direct addition of TransTint dye solution to Tried and True Danish oil (per instruction by Rob Millard and Jeff Jewitt) for the purposes of bringing a nice rich brown to a mahogany G&G table I'm trying to finish up. I had some QS sycamore left over from another project, so I thought I would give my dye solutions a shot FWIW. Here is a pic. On the far left is pure T&T danish oil. The next panel is TransTint reddish brown (#6003). The next panel is TransTint medium brown (#6004). The next panel is a 50:50 mixture of the two TransTints. The last panel is untreated wood. Prior to dyeing, the wood was sanded quickly with a ROS with 150, 180, 220 grit. No other finish was applied. On mahogany, I am VERY pleased with the 50:50 mixture. Hope this helps.

Jim


img