Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Stupid electrical/EMT question

Posts

Stupid electrical/EMT question

#1

Stupid electrical/EMT question

wilbur

>I want to add in an additional outlet in my shop. I think I've figured out how to work with EMT, which is what all the other wiring is done with. I have a pipe cutter that I've used with copper pipes. Will the same cutter cut down EMT as well, or do I have to get the special EMT cutter that I saw at the borg, conveniently located next to the EMT?

Re: Stupid electrical/EMT question

#2

JL

Re: Stupid electrical/EMT question

JL

>The walls are thinner with EMT conduit, so you have to remember not to crank down as hard or as far. With that caveat, yes you can use it.

Unless you feel you really need another tool to store - and if that is the case, let me send you a couple boxes :).

Re: Stupid electrical/EMT question

#3

Re: Stupid electrical/EMT question

Rod Peterson -- Ormond Beach

>Are you talking about a pipe cutter (ala big Ridgid for galvanized) or a tubing cutter (for copper)? I've used a tubing cutter for years for EMT. The only thing to watch for is the burr raised on the inner aspect of the cut (just as with copper) which doesn't respond nearly as well to the deburring blade of the cutter as does copper. You do want to make some effort to knock that burr down, as insulation doesn't resist very well the cutting action of it. DAMHIKT.

Nothing wrong with a hacksaw, either, and it's much easier to deburr.

Rod

Re: Stupid electrical/EMT question

#4

Thats what I use...

john in NM

>I do so little condiut work, its just not worth it to have a dedicated cutter. Bur does get pretty big, especially after a few years when the cutter is dull (easy to replace the wheel(s) though).

Re: Stupid electrical/EMT question

#5

Re: Stupid electrical/EMT question

Howard Norman

>I have been worded with EMT for most of my life on a casual basis and never found the need for a specific EMT cutter. If you do it forty hours a week that would be another story. I have used hacksaw, tubing cutter, Sawzall and probable other cutters over the years. As others have said you need to remove the burr before you assemble the conduit. When I used to do a lot of 1/2" EMT work a kept a tapering tool in a brace and used that to deburr the conduit.

Re: Stupid electrical/EMT question

#6

Re: Stupid electrical/EMT question

Stuart Johnson

>I use a sawsall and an electrician pliers to deburr.

Re: Stupid electrical/EMT question

#7

Re: Stupid electrical/EMT question

JoeW in Detroit, MI

>I was trained to use a hacksaw on EMT because a plumbing pipe cutter will leave a sharp edge. I use channel locks to de-burr.

Don't forget to use a bushing on the top. There a press-on plastic one avalbe that cost about 25 cents/piece.

Re: Stupid electrical/EMT question

#9

Re: Stupid electrical/EMT question

NickB in Eastern Mass.

>I've done a couple of shops, mostly with EMT, and tend to use a pipe cutter (no moving or clamping required), but a hacksaw works just as well. To my mind, it doesn't matter what you use as long as you deal with the burr (I ream, then clean up with a rat tail file most of the time).

Hope this helps,

Nick