Spiral Router Bit Questions.
Barry Irby
>I have been using a router to cut oak flooring to make patches. Made a template I can kneel on that allows me to cross cut the flooring so I can "tooth" the floor back together with staggered joints. I have trashed two carbide 1/4" bits at $14 each hitting nails. So I went to Harbor Freight and bought 3 packs of spiral bits for $6.79. (HF did not have single or family packs of regular bits.) They are HSS and about 3" long with about half of it fluted and 1/4" in diameter. I don't have experience with spiral bits. Are they prone to break? I am making three passes of a 1/4" depth each time, not trying to cut the full 3/4" floor in one pass.
Should I set the bit deep into the collet? Or just up to the flutes? Seems that deeper would support the shank better, but the flutes might damage the collet.
If one breaks, do they fly around like bullets or just snap and sit there.



