Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

OT: downspout drip noise

Posts

OT: downspout drip noise

#1

OT: downspout drip noise

Dan Mitchell

>One of the downspouts from the 2nd story of our house drains into some of that corrugated drainage pipe, about 6" in diameter. The downspout runs down the side of the house, in the middle of the living room, dropping about 20'. Believe it or not, the dripping from the height of the gutter to the drain pipe below is annoyingly audible inside the house. Tap, tap, tap, tap, tap... Living somewhere known for its precipitation (Seattle), it can go on for hours. Days. Who am I kidding, MONTHS! ;-) I'm wondering if there is any way to silence this drip w/o compromising the flow through the downspout. Any ideas?

TIA

Dan

Re: OT: downspout drip noise

#2

Re: OT: downspout drip noise

Ken Bellock (Houston, TX)

>There may be a better solution, but without seeing your setup, I would propose this. Go to an audio store, I think even places like circuit city and best buy carry it, and look for a product called dynamat. They used to sell it in licence plate sized strips, and a little goes a long way. Cut off a strip of it, and peel off the cover to the self adhesive underneath. Then you can stick it on a non-visible side of the area of your downspout that is resonating the noise. It will change the acoustic properties of the sheet metal which is amplifying the sound of your drip, and hopefully stop the sound from making it in your house.

Hope this helps,

Ken

Re: OT: downspout drip noise

#3

Re: OT: downspout drip noise

Carol - now back in Dubuque, IA

>Is there a way to provide a surface for the water to flow on as opposed to the free fall of drops of water?

A chain or wire connecting the gutter to the downspout, as an example.

Re: OT: downspout drip noise

#4

Re: OT: downspout drip noise

Kneale Brownson dreaming of snow in N. MI

>If you ran the wire down the length of the downspout and adhered the upper end to the lowest point in the gutter, the last little bits of moisture would flow down the wire instead of freefalling drip by drip, I'd think.

Re: OT: downspout drip noise

#5

Re: OT: downspout drip noise

Rob Stokes in North Vancouver

>In the past I've put a big rock in the pipe for the water drips to hit. But this only works if you can be sure you leave enough room for the potential flow in a rainstorm.

Rob

Re: OT: downspout drip noise

#6

Re: OT: downspout drip noise

John K Jordan

>If you could tilt the downspout a little in one direction or another the drips might only fall a quiet short distance before hitting the sides and flowing silently to the bottom.

Or take a look at how the gutter drain enters the top of the pipe and see if it can be bent a little to one side to effect the same.

JKJ

Re: OT: downspout drip noise

#7

A piece of rope....

Grant in Iowa

>Two solutions come to mind:

1. Suspend a piece of parachute cord or clothes line inside the downspout so the water drains down it, instead of dripping. Make a crossbar out of heavy wire such that it collects the water. Capillary action will do the rest.

I believe your area is where there are often chains used for the same effect.

2. Reset the downspout such that it is not plumb. This will cause the water to run down one side of the downspout.

FWIW,

Grant in Iowa

Re: OT: downspout drip noise

#8

My cure

Bill Howatt

>Had a similar problem when we had aluminum seamless eavestrough and downpipes installed. Our house is cedar so it doesn't deaden the sound like brick does. Also, the downpipe was near a window.

I changed the aluminum pipe for a vinyl one which helped a little. The real cure was unfastening the down pipe from the side of the house. It is now still fastened but rather loosely with long screws that are barely screwed into the wall. There is at least a 1" air gap between the pipe and wall along its entire length. Our house is only a single story.

This is the only thing that worked for me.

Bill

Re: OT: downspout drip noise

#9

Re: OT: downspout drip noise

Barry Irby

>You must have an edge of some description the water is dripping off near the top. Look at whatever is hooked into the downspout at the top of the straight vertical run. Whatever that fitting is, that's the problem. If you can change the fitting so that it is snug inside the DS, the water will drool silently down the ways rather than drinking. If it is an elbow or a "drop" or basket out of the the gutter you might be able to slit the bottom of it (like fingers) and expand it enough to make contact with the walls of the DS and stop the dripping. Or you could install a liner of tape or metal in the DS as a surface for the water to run on.

It takes a space of about a 1/4" to make the drip. Less than that and the water tends to bridge the gap and drool.

It's not the local practice, but if your downspouts drop straight out of the gutters without offsetting elbows, you might be able to do this from the top without removing the DS. Could be as simple as slapping the DS on on side to shift the top to eliminate the gap on the side the water comes from.

Re: OT: downspout drip noise

#10

Re: OT: downspout drip noise

Jim Dillon

>Dan,

What about a small piece of window screen cut to slightly bigger than the downspout and wedged just inside the bottom of the downspout? Might break the fall of the rain drop enough to stop the racket. The downside, if you have a lot of leaves/pine needles etc., is clogging - but at least you would get a good nights sleep.

Jim

Re: OT: downspout drip noise

#11

My thought also

Lee Schierer - McKean, PA

>I was thinking the same thing as I read the original post. I would use 1/8 or 1/4" nylon woven rope rather than cotton clothesline so that it will last more than one season.

Re: OT: downspout drip noise

#12

Re: OT: downspout drip noise

Dan Mitchell

>Thanks for all the great idea, I though this was an odd-ball question, but I guess I'm not the only one with the problem. I think I'll try the rope approach 1st ;-)

Dan