Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

18 ga brad nailer jams - fix?

Posts

18 ga brad nailer jams - fix?

#1

18 ga brad nailer jams - fix?

Tim Greif - West of Chicago

>My trusty brad nailer has just this weekend developed a nasty habit of jamming when firing 1.5" nails. Probably 10-20% of the time, it leaves the brad exposed to some degree and I have to pull the nail out. Can this be fixed by re-filing the firing pin blunt again, or do I need to just replace it. Never a problem until now. And for some odd reason, only on the 1.5" brads. Works just fine on the 5/8" brads I was using before them.

Re: 18 ga brad nailer jams - fix?

#2

Re: 18 ga brad nailer jams - fix?

BILL White

>What kinda gun (as in brand)?

Bill

Re: 18 ga brad nailer jams - fix?

#5

Not sure I understand that one

Tim Greif - West of Chicago

>I'm not quite sure how that would help. The firing pin is slipping past the nailhead. It fires the brad, but it just slips past and jams in the discharge. I have to pull the gun real hard to dislodge it from the brad, or open the discharge piece to clear it.

but come to think of it, I did have the pressure dialed down to around 55 psi, not the normal 80-90 I generally use. I'll try that.

Re: 18 ga brad nailer jams - fix?

#6

Re: 18 ga brad nailer jams - fix?

Terry in Edmonton

>Some of the nailers will only drive certain length brads. If 1.5 are new for you your nailer may not like them. My PC nailer doesn't like them for example but my Hitachi does. It did mention that in the owners manual but I had to figure it out the hard way.

Re: 18 ga brad nailer jams - fix?

#7

Re: Not sure I understand that one

Pete LaBelle

>Yea, low pressure will make the gun do wierd things & not drive the nail all the way in. Pressure is very important on longer nails and harder woods.

Re: 18 ga brad nailer jams - fix?

#8

Not the case here.

Tim Greif - West of Chicago

>I've probably used up almost half a box of those 1.5" brads on numerous projects without a hitch. My gun takes 5/8" - 2" brads. I've used both extremes. I think this air pressure thing may be the problem. I had dialed it down to 55psi for the 5/8 brads when fastening half laps. I wanted to make sure the brad didn't go through the "good" side of the combined 3/4" finished thickness. I forgot to set it back up when changing to the 1.5" brads and that's exactly when this all started.

Re: 18 ga brad nailer jams - fix?

#9

Re: If the pressure doesn't fix it

Glenn Madsen near San Francisco

>then maybe it's time for the $20 Harbor Freight brad nailer special...

But fussing with the pressure usually works things out on my Porter Cable guns...

Re: 18 ga brad nailer jams - fix?

#10

OK thanks guys, it was indeed the air pressure

Tim Greif - West of Chicago

>I dialed it up to 90 psi and was not able to get it to misfire or jam even once using those same 1.5" brads. Thanks for the tips.