Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

Considering used Atlas sander, opinions? *LINK*

Posts

Considering used Atlas sander, opinions? *LINK*

#1

Considering used Atlas sander, opinions? *LINK*

Dan Mitchell

>I'd like to get a belt/disk sander & saw this one on Craig's list. Looks like it could be worth considering. Anyone have an opinion on the machine/asking price?

Thanks

Dan


http://seattle.craigslist.org/see/tls/848652641.ht

Re: Considering used Atlas sander, opinions? *LINK*

#2

Re: Considering used Atlas sander, opinions?

Ken Oakley-Sunny St. Cloud, Fla

>If it was me I'd jump all over it. Atlas made some fine machinery. In fact they made some for Sears when Sears sold a decent product. I worked on a 12" Atlas metal lathe in the 60's that was the same one Sears sold with the Craftsman name. That sander looks like the Craftsman I bought from Sears in 1962 and still use daily with out one problem in all those years,

Re: Considering used Atlas sander, opinions? *LINK*

#3

JL

Re: Considering used Atlas sander, opinions?

JL

>Go for it - but make sure that you improve your dust collection :).

You may need to improvise a hood that you can hang on the stand - but the stand looks sturdy enough to support it.

Re: Considering used Atlas sander, opinions? *LINK*

#4

Oh yes........

Mark Goodall - ATL - tooljunkie

>Hard to tell from the pics, but if that's mostly cast iron and it runs....... well, if you don't buy it I will.

Happy Woodworking!

Re: Considering used Atlas sander, opinions? *LINK*

#5

Re: Considering used Atlas sander, opinions?

Tom MacGregor

>Most of my machinery is 40's-50's era cast iron - Dunlap, Homecraft (Delta), Atlas & etc., mostly bought at salvage prices & restored. I wouldn't trade a piece of it for new stuff. With a stand & a Baldor motor that's reasonable. Make sure there's not any run-out or wobble as it's probably got a bronze sleeve bearing and that could be difficult to fix. As the body of the sander is (I presume) hollow and open at the bottom consider cutting a hole in the stand and installing downdraft dust collection. That works very well for me.

Re: Considering used Atlas sander, opinions? *LINK*

#6

Re: Considering used Atlas sander, opinions?

Howard Norman

>As long as the bearings are not shot-buy it. If the bearings are bad investigate the type of bearing and determine if it is available. Price is right IMHO.

howard

Re: Considering used Atlas sander, opinions? *LINK*

#7

Re: Considering used Atlas sander, opinions? *LINK*

Dan Mitchell

>Thanks for the replies. I wrote the seller with a couple questions, awaiting a reply. I agree it COULD be a great machine, though I too am a bit concerned about dust collection on this machine from the era when "Real mean didn't wear (dust, noise, etc.) protection" ;-) That and condition issues around possible bearings. We'll see.

Also looking at this Grizzly:


http://www.grizzly.com/catalog/2008/Main/145

Re: Considering used Atlas sander, opinions? *LINK*

#8

Re: Considering used Atlas sander, opinions?

Chuck in ND

>When did Grizzly start makeing a open machinery stand that looks ALOT like the old Delta/Rockwell stands ?