Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

On sanding curved parts

Posts

On sanding curved parts

#1

On sanding curved parts

Bill Tindall, E.TN

>I picked up this tip from Will Neptune at last year's SAPFM meeting. The block is a piece of wood with a multitude of slits to make it flexible. Glued to it with 3M 90 high strength adhesive is Klingspor's J-Flex sanding cloth. The object is the domed trunk lid, in need of stain to bring out its quarter sawed figure.

If you have not tried this paper for turned and curved objects you should try it. It lasts times longer than paper and cuts rapid. Additionally, it is as limp as a worn tee shirt. I smoothed the whole of this top with two charges of 80 grit and I removed a mountain of wood ( and made a cloud of dust) to fair the curve.

Re: On sanding curved parts

#3

Thanks Bill,

George@Colonel's Workshop-Havertown PA

>Good Afternoon Bill,

I have several residual pieces of that J-Flex left over from a "mystery box" they sent me a year or so ago. You provided great illustrations in that one photo. Do you keep your sanding supplies in that chest? :<)

George

Re: On sanding curved parts

#4

Re: On sanding curved parts

Dick Coers

>Nice tip Bill. Made me think that if you glued a thin piece of wood to the top of the kerf cut piece while it was on the curved top, you would have a block with a fixed curve to it. If all was flexible enough, you could probably get a slight reverse curve as well. Might try that the next time I make ogee feet. I'll use it for sure the next time I make my own large crown on the table saw. Thanks again.