>Mine were marked Amana bits for the standard, and Frisch bits for metric. They have served me well but I baby them and I've always wondered who really made them. None are sawtooth.
>I bought a set of carbide tipped forstner bits from Woodcraft a few years ago and they are wonderful. Where others start to get dull after a bit, these go and go. I only use them for deep hollowing (before turning peppermills, etc) so I can't comment on the relative quality of the finish of the hole.
>I've been real happy with the bits I purchased from Lee Valley. Clean cuts, less heat, etc. I mostly use them for typical shop stuff in 3/4" material like maple, mahogany, etc.
>I used to buy a Forstner bit when I wanted one for a particular project, then I finally had Bosch send me their cased set of 16 and for high speed steel , they are a very fine tool.