Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

45 deg, zero clearance TS insert

Posts

45 deg, zero clearance TS insert

#1

45 deg, zero clearance TS insert

Dan Mitchell

>Is there a way to make a 45 degree, zero clearance table saw insert? I've made dado ones, & I have a 90 deg zero clearance, but I'm wondering how you'd precisely cut the angled slot for the blade in a 45 deg insert. Obviously, you can't just raise the blade into the insert like you would for a 90 deg type. Depending on the saw, putting it in place may be tricky was well. Has anyone ever made one of these?

Dan

Re: 45 deg, zero clearance TS insert

#2

Ellis Walentine

Have not done it, but...

Ellis Walentine

>... I don't know why you couldn't raise the blade through the blank just as you would with a 90� throat plate. You'd want to make sure the blank was securely held in the opening, like with a board clamped over it. I hesitate to recommend the procedure since I haven't done it myself, but in theory it should work.

Ellis

Re: 45 deg, zero clearance TS insert

#3

I have done it,

Lee Schierer - McKean, PA

>To make a 45 degree zero clearance insert you do it exactly like you would a 90 degree insert. Put the blank in place, turn on the saw and raise the blade through the wood. The saw and the wood don't know they are at and angle. It works just fine!

Lee

Re: 45 deg, zero clearance TS insert

#4

Re: 45 deg, zero clearance TS insert

Jim Dillon

>Dan,

Agree with the others. While I have not made a 45 degree insert per se (but have made plenty of 90 degree and dado inserts), I have cut a 45 degree slot in my TS sled for a special project. Just raised the blade up through the bottom of the sled. For regular inserts, I place the TS fence across the edge of the insert to hold it down while cutting the slot. Should be doable, but maybe I'm missing something here. I just remembered that I have run into a problem when using a thin-kerf blade with a stabilizer attached. The stabilizer prevented me from raising the blade as high as I needed when cutting the insert, so I just took the stabilizer off.

Jim

Re: 45 deg, zero clearance TS insert

#5

I made one this last weekend

Bruce, a MN Galoot

>On my contractor saw, the blade doesn't retract enough to allow clearance between the bottom of the insert and the top of the blade, so what I did was put in a smaller diameter rip blade. That provided enough clearance, and then I raised it through the insert. With that first cut made, there was enough room to make successive cuts with my larger blade. BTW, I clamped the insert in place so that there was no chance of it lifting as I raised the blade.

Piece of cake.

Bruce

Re: 45 deg, zero clearance TS insert

#6

Re: 45 deg, zero clearance TS insert

Dan Mitchell

>Thanks for the replies. In my mind's eye, I was picturing the blade raising "straight up" not in line with the angle. Guess I should have just looked at the saw! I see now it's the same as a 90.

Dan