Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Can't get a grip on it---clamps

Posts

Can't get a grip on it---clamps

#1

Can't get a grip on it---clamps

BobP

>Good day WCers.

I have an ongoing problem with some of the Quick Grip (Irwin) mini bar clamps that I own. I have some older units (all black) that grip with considerable pressure before any hint of slipping. I have some newer clamps (blue jaw pieces) that just cannot apply much clamping pressure before they begin to slip. The older, good, ones have the words "Quick Grip" dominant on the label. The newer ones that slip have "IRWIN" dominant on the lable with "Quick Grip" just below (they have blue colored jaw pieces).

Has anyone else run into this situation and is there some sort of "fix" that can be applied to get the clamps that slip to be clamps that grip??

Your help and comments are greatly appreciated as I have about 8 of these units with varying degrees of clamping power. I just want the NEW ones to work as well as the OLD ones.

Thanks

BobP

Re: Can't get a grip on it---clamps

#2

Re: Can't get a grip on it---clamps

Don Wurscher

>Same Problem, reversed the trigger, works now, looks goofy, but what the hay.

Re: Can't get a grip on it---clamps

#3

Re: Can't get a grip on it---clamps

Jerry Gibbs

>did irwin have some sort of recall. if they did, i was busy and missed it. jerry gibbs

Re: Can't get a grip on it---clamps

#4

Fix is easier than the explanation

Larry Marker

>I had the same problem so bad I was about to throw away four new clamps that I had just bought, but then I read the solution here about a year ago. I tried to find it in the archives but failed. Here is a poorer explanation (working from memory -- I hope I got this right):

1 - drive out the cross pin in the end of the bar -- youy will need to slide the movable part off the bar in a minute.

2 - pry off one or both sides of the clamp -- the part where the Irwin name is.

3 - carefully remove the movable jaw

4 - remove the little metal plate that jams the jaw to the bar and turn it around so that the face that used to be toward the fixed jaw is now toward the open end of the bar.

5 - put it all back together.

I did this to mine and they are all now as good as my old QuickGrips.

Larry

Re: Can't get a grip on it---clamps

#5

Re: Fix is easier than the explanation

BobP

>Thanks for the tip.

I am going to try your suggestion tomorrow. I'll let you know how I make out.

BobP

Re: Can't get a grip on it---clamps

#6

Re: Can't get a grip on it---clamps

del schisler

>take the pin out of the end and take it apart Turn the 2 pieces the slide on the bar and trun them around That is what i did and that fix them