Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Removing wax from burl blank

Posts

Removing wax from burl blank

#1

Removing wax from burl blank

Dan Mitchell

>Recently bought a block of Imbuia burl at Rockler to make a "bandsaw box", which will be a birthday gift for my wife's mother. The cube, roughly 6" on a side, is coated in wax. I'm wondering what the best method would be for removing the wax. I know I could cut it off in thin layers, resaw-fashion, but as seen in the pic, the block has a rough "bark" portion which I would like to retain in the box's cover. The marginally-helpful sales clerks at Rockler suggested a heat gun, which I do have. I guess you just heat the wood until the wax drips/can be wiped off. Hard to imagine this would remove it thoroughly enough to get a decent finish applied. Is this the best approach, or are there better methods? A solvent, perhaps?

This is my 1st experience in dealing with one of these blanks, of any species. Insights into any part of the process would be appreciated.

TIA

Dan


img

Re: Removing wax from burl blank

#2

Steven Antonucci

Try thinner and a toothbrush.

steve antonucci

>I don't know what kind of wax it is, but I bet it is soluable in thinner...

Steve

Re: Removing wax from burl blank

#3

5 Minutes of Fun for $2

Mark Mandell - Gone Round In Jersey

>Down at the self serve car wash. Little hot soap and 2800psi rinse and you should be good to go.

[As long as you don't mind the strange looks you'll get from the guys in the other stalls ] |;-}}}}

mm

Re: Removing wax from burl blank

#4

Re: 5 Minutes of Fun for $2

Dan Mitchell

>Have you actually done this?

Would my power washer work as well without the potential embarrassment?!?

Thanks for the replies.

Re: Removing wax from burl blank

#5

Re: 5 Minutes of Fun for $2

Mark Mandell - Gone Round In Jersey

>That's how I do my wax-covered stuff. Wax, especially paraffin, does not penetrate wood pores. Most wax coatings, like Anchorseal, contain an emulsifier that remains in the film after the water has evaporated. Rewet it and the stuff rinses right off. Warm/hot water works best, so that's why I go to the car wash joint.

"Honest, Hun. There was this crazy dude power washing a chunk of wood in the stall next to me."

"Yeah, well judging from the job you did on my car, I ain't surprised. You stop off at Clancy's before or after the car wash?"

|;-}}

Re: Removing wax from burl blank

#6

Re: Try thinner and a toothbrush.

Fred Davis

>Steve is right about using mineral spirits to remove the wax, but instead of a toothbrush , try hardwood shavings wetted with thinner for the rough part on your block.

While power washing cleans , I doubt you will remove any significant amount of wax , but you will undoubtedly get it wet which is counter productive to prepping wood.

FredD

Re: Removing wax from burl blank

#7

Mineral spirits dissolves wax

Michael Dresdner

>