Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

bow in table top boards

Posts

bow in table top boards

#1

bow in table top boards

Erick Singleman

>When I made my table top boards I resawed 3/4" curly maple to have book matched surfaces. I planed these down to about 1/4" and glued them (yellow glue)to 3/4" non-figured maple boards that were dead nuts straight. When I removed the clamps there was about 3/16" to 1/4" of bow in the glued up boards. I figure this is due to the moisture absorbption from the glue line that is not in the center of the board. I put the boards out int he sun for an afternoon and two of the four straightened out completely. The others still have some way to go. I assume they will flatten out when the moisture content of the wood evens out again?

Re: bow in table top boards

#2

Re: bow in table top boards

Thomas Skaggs, Foothills of Mount Level

>Your bowing might be a result of the resawing. That can happen when there is a differential in moisture from the inside of a board to the outside faces.

Did you say you glued the cherry to a maple substrate? If so, you might have some additional concerns to reckon with.

Tom

Re: bow in table top boards

#3

Re: bow in table top boards

Erick Singleman

>The resawn curly maple had a slight bow in them not too much, but they actually bowed the opposite way to how the glued up boards bowed. I glued the maple to maple.

Re: bow in table top boards

#4

Bow, or cup?

Bill Tindall, E.TN

>Are the boards bowed, or cupped. If cupped, which is what I would expect, read the article in Workshop News September 2008 by Ian Kirby on this topic. One would expect boards to cup when veneered on one side do to shrinkage of glue.

If in fact they are bowed then straighten them on a jointer.

Re: bow in table top boards

#5

Re: Bow, or cup?

Erick Singleman

>They are in fact bowed. And the veneer if you want to call it that is 5/16 thick.

My Jointer is only six inches and the boards are 8 1/2". So I think that is out. Since the moisture of the glue made it bow, it think it should straighten out when the moisture in the two sections veener and base even out. I haven't checked the boards in a few days, had to watch the Giants beat the Redskins last night. Two of them did straighten out, I thinkthe other two are just slow.