Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

45 degree lck miter router bit

Posts

45 degree lck miter router bit

#1

45 degree lck miter router bit

mike@American Sycamore

>Dear Woodworkers;

I am in need of using a 45 lock miter joint and I have real good luck on short sample set up pieces but running a 36" leg is very difficult. I am using my router table with small stock feeder. Do you think I would get a better cut going to a shaper cutter and using my big stock feeder on my 3hp shaper?? I would like to discuss this with someone that is getting a tight joint with either cutter. thanks,

Mike

Re: 45 degree lck miter router bit

#2

Re: 45 degree lck miter router bit

Fred Davis

>Yes,

FredD

Re: 45 degree lck miter router bit

#3

Re: 45 degree lck miter router bit

mike@American Sycamore

>have you tried with a router bit? What shaper, feeder, and brand of cutter are you using? Is it still a lot of set up to get one to come out correct? Waste a lot of material? Is the joint worth it?

thanks,

Mike

Re: 45 degree lck miter router bit

#4

Rick L

Re: Much easier ways to do legs...

Rick L

>You like to torture yourself. I find it a lot simpler to use a 45 degree cut and the strapping tape folding method. I prefer the Merle clamp at MLCS but ant bandclamp will work.

Too many articles use the lock miter bit. I suspect they are paid by the router bit companies. I only use it on three sided fake box beams.

Re: 45 degree lck miter router bit

#5

Re: Much easier ways to do legs...

mdclor

>I also cut mine with the TS at 45*, but add a spline for alignment.

FWIW,

Merle