Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

PC news for George@Colonel's Workshop at all

Posts

PC news for George@Colonel's Workshop at all

#1

PC news for George@Colonel's Workshop at all

Barry Irby

>I posted a response to your query about bearings for the 690 router you got free. I basically shot from the lip and said I thought you could get the bearings for 10 or 20 bucks. Then I thought better of it and tried to check the price of them at the Delta/PC/whatever web site. I have shopped there on their Service.net thingy before.

I could not remember my pass word and tried to set up a new account. Got tangled up in the BS and ticked by the fact that they wanted my address three times and my phone number twice and would not allow me to proceed until I entered it and then had to enter the phone number in two different formats. At that point I said screw it. But I was ticked and sent them an E-Mail to the effect that their website was stupid, redundant, insulting, and made the old fuddy duddy in me feel like a geezer. Why would they do that? Really stupid to offend the geezers. I own a lot of tools that need parts.

I am amazed. I got a phone call from them. They were very concerned and said they were working on the website and knew it was a disaster. Looked up the parts for me and told me what they cost, More than I expected. Bottom bearing was about $25 and top one about $10. Said I should tell you to be careful and be sure you had all the numbers etc. because there have been about nine incarnations of that router. Then I got a follow up e-mail.

It did not actually do me any good, but I am impressed. Usually sending an e-mail to such places is like writing to Santa Clause without the warm fuzzy feeling. Maybe they really are trying. I hope so.

Re: PC news for George@Colonel's Workshop at all

#2

Just A Note On Bearings

Mark Mandell - Gone Round In Jersey

>You will often find their part #s in your manual and that number will actually be the NTN Bearing #. For routers they are always double sealed bearings, and you can get them direct from the NTN website.

Example: My Ryobi 600E took a #6004LLB main bearing, so I went to the NTN site and found the bearing for less than Ryobi charged.

Re: PC news for George@Colonel's Workshop at all

#3

Re: Just A Note On Bearings

Ron In Sterling CT

>I worked a fair portion of my career in the bearing/seal industry. My recommendation is to ALWAYS buy your bearings direct from the bearing manufacturer, or a bearing supply warehouse if you know the part number, as opposed to buying from the tool manufacturer. You will save money, and usually get a better quality product.