PC 4212 for cheap?!? *LINK*
Dan Mitchell
>Anyone aver heard of/used this place? This jig goes for 40 bucks more at Rockler/Woodcraft. Shipping to my zip adds about $18, only a little more than the local tax on $169.99.
A&H Turf & Specialties
Knowledge You Can Build On — Est. 1998
PC 4212 for cheap?!? *LINK*
Dan Mitchell
>Anyone aver heard of/used this place? This jig goes for 40 bucks more at Rockler/Woodcraft. Shipping to my zip adds about $18, only a little more than the local tax on $169.99.
A&H Turf & Specialties
That page showed the 4210, which does not.........
Art Silva
>have the the template for through dovetails at $129.
Re: PC 4212 for cheap?!?
George@Colonel's Workshop-Havertown PA
>Hello Dan,
I'd keep looking. You can always spend money. I've seen two #4212 jigs on sale at Craigslist over the past several months, and they were good deals. I believe I bought mine from Amazon. I've used it pretty often for box and thru-dovetail joints.
George
You're right! duh...
Dan Mitchell
>It was pretty late when I found that, (specifically searching "Porter Cable 4212") must have been half asleep! ;-)
Dan
An Upgrade is Expensive.
George@Colonel's Workshop-Havertown PA
>Good Evening Dan,
I was in Woodcraft this afternoon and asked how much it would cost me to replace my thru dovetail/box joint template for my P+C 4212 jig. Over $70! I know its very precious Chinese Aluminum, but 'taint worth that money. I had a slight problem with the templete when I forgot to install a collar in the router base, and the bit "walked" all over the brand new template. Well, it isn't new anymore! Fortunately it is still usable, but the etching/guides are very hard for me to see when I set it up. So, take the cost of the thru template into accouibnt if you are tempted to buy the 4210.
George