Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

hardwood floor refinish prob

Posts

hardwood floor refinish prob

#1

hardwood floor refinish prob

Steve Jenkins, McKinney, TX.

>We had some new oak flooring installed then all the floors refinished. We wanted a satin look but the installer talked us into a "wax" finish. It was so slick you couldn't walk on it in socks and was really squeeky with tennis shoes. We had him redo them.

Originally they were done with 2 coats of Duraseal Golden oak then waxed. when he redid them he used a buffer with a steel wool pad and Duraseal finish restorer.

Now in a lot of areas it looks like there is no finish at all and has lots of swirl marks.

We have no desire to call him back again so I'm going to give it a shot myself if I can figure out what to do. That's where you come in. I need some advise.

Thanks

Steve Jenkins

"Always use the word impossible with extreme caution"

469 742-9694

Re: hardwood floor refinish prob

#2

Re: hardwood floor refinish prob *LINK*

JimG

>My wife and I installed our floors few years ago. We used Bona Mega. Anyway, if you really want to do it yourself, I suggest the book Hardwood Floors: Laying, Sanding and Finishing (Paperback)

by Don Bollinger. He also has a companion video, which is really good.

HTH

jim


http://www.amazon.com/Hardwood-Floors-Laying-Sanding-Finishing/dp/0942391624

Re: hardwood floor refinish prob

#3

more practical than you may think

Bill Tindall, E.TN

>With the floor already flat it will be a quick job to scrape the swirl marks away with a floor scraper available from Lee Valley or flea markets. See my article in the Articles section on floor scraping.

Your experience is exactly why I scraped my floors to begin with. I have seen many more floors ruined by "professional" finishers than I have seen done properly.

Re: hardwood floor refinish prob

#4

Re: hardwood floor refinish prob

Dick Coers

>I'm going to say that the wax will be a bigger problem than the swirl marks. I suspect the look "of no finish at all in some areas" is because the new finish he put on didn't stick to some areas because of wax contamination. You will probably have to sand it all back down and wash the floor a couple of times with mineral spirits to get the wax off the surface. You are still going to have it in the cracks between the boards, but that shouldn't effect how the clear coat sticks.

Re: hardwood floor refinish prob

#5

wax on wax off

Steve Jenkins, McKinney, TX.

>How do deal with the wax is my main concern. I wasn't sure if I neeeded to sand it down or just try to wash it off. sounds like probably both.

Thanks

Steve