Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

airbrush woes

Posts

airbrush woes

#1

airbrush woes

peter kolb

>I own a Badger 150 airbrush and I can not get it to spray water let alone paint. Passage of air in and out of the brush seems normal. Any ideas what the problem might be? Thanks for your help. Peter in south central nj

Re: airbrush woes

#2

Re: airbrush woes

Clint Searl, at the base of Haycock Mtn

>Airbrushes are notoriously fickle. I played with several for a while with increasing frustration. I replaced them with a Sata top loading detail gun and have found lasting happiness.

Clint

Re: airbrush woes

#3

Re: airbrush woes

charlie belden

>Peter Kold wrote:

I own a Badger 150 airbrush and I can not get it to spray water let alone paint. Passage of air in and out of the brush seems normal. Any ideas what the problem might be? Thanks for your help. Peter in south central nj

============================

Possibilities:

- feed tube from bottle to brush clogged

- small "air" hole in top of bottle is plugged

causing a vacuum to form in the bottle.

- mismatch of needle and tip, needle too small

and set too far foreward. When you pull

the trigger back it continues to fill the hole

in the tip.

Re: airbrush woes

#4

Re: airbrush woes

Bill Howatt

>Most airbrush problems are caused by "dirt". Did you try all the cleaning techniques including disassembly and cleaning? Thorough cleaning and keeping it clean are part of airbrush life. When you consider the amount of cleaning required for a big sprayer it is not surprising that the little ones are a bit fussier. Be sure you use good quality airbrush paint - not general craft paint for best operation and reduced maintenance.

Bill

Re: airbrush woes

#5

Re: airbrush woes

peter kolb

>Clint, thanks for sharing. Charlie excellent suggestions. Bill thank you for your comments. Peter in south central nj

Re: airbrush woes

#6

Re: airbrush woes

peter kolb

>Problem solved. I installed the wrong spray regulator. Solution Large needle-large spray regulator. Thanks again for your help Peter in south central nj