I Have Figured Legs!!
Jim Shaver - Oakville, Ont
>Okay, so I was teasing...but mine aren't bad, eh
:-)
I am working on a piece for my daughter and I wanted to make mitered legs. In the past I had done so with a mitre lock router bit and lots of time in set up. Some years ago I received some clear advice from steve Jenkins about just doing the mitre cuts on the table saw and a simple glue up. So taking Steve's wise advice I did the following.
I selected boards that had nice figure and clean long grain, these are all qs white oak, some with curly figure. I ripped sequencial leg strips from the selected boards and then laid them out.
I used clear packing tape to hold them and as clamps in the glue up.
Thanks Steve!
Take it Easy,
Jim




