Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Performax 22-44 problem

Posts

Performax 22-44 problem

#1

Performax 22-44 problem

doug f, san clemente, ca

>I have what sounds very much like a bearing going out on a 3 year old 22-44 (high pitched squeal when sanding). I'm a woodworker, not a mechanic, and I don't have the faintest idea how to remove and replace a bearing. One of the problems with this machine is it's HEAVY; making transportation anywhere a major undertaking.

Anyone have any suggestions?

Thanks for your help as always.

Doug

Re: Performax 22-44 problem

#2

Re: Performax 22-44 problem

galen V

>Maybe go to WMH Tool Group web site and try a serch for service centers for sanders. I did and they come up with at least three close to San Clemete. Maybe give them a call and see what kind of assistance they can give. Most have 5 year warranty so maybe at least get free bearings, if that is problem. Unless on line manual is poor the drum bearings look like simple two bolt flange bearings and clip retainers. Seems like they should be easy to inspect. Small flexible drive coupling has rubber spider and maybe see if this is getting chewed up from either bearings allowing too much movement or maybe just too much load. Load cushion may just need to be replaced.

Just some comments and suggestions. Don't own, just mechanical engineer and like machines.

Re: Performax 22-44 problem

#3

Re: Performax 22-44 problem

doug f, san clemente, ca

>For us non-engineering types it looks a bit daunting, but I guess I'll try and remove the bearings. The service center opens at 8:00 AM tomorrow so my first call will be there; then I grab my trusty socket wrench and have at it.

Thanks for the suggestions.

Doug

Re: Performax 22-44 problem

#4

Re: Performax 22-44 problem

galen V

>Just good things to do. Open the dust hood and take digital pictures of both ends to show bearings and coupling. Sometimes better to understand than exploded parts view. Have the Drum head assembly view of you manual out for call. Good service guy should be able to talk you through steps if there is anything special to watch out for. At least you know you need snap ring pliers and wrenches to fit bearing cariage bolt nuts and probably allen wrenches to fit coupling half.

I got needle nose pliers I ground to fit some snap rings and they work better than my cheap snap ring pliers tips anyway.

Well there are always guys who can take things apart and not put back together, my younger brother being one of those! Good luck!

Re: Performax 22-44 problem

#5

Re: Performax 22-44 problem

JRutter

>Sounds like the belt might be loose. Check that first.

Re: Performax 22-44 problem

#6

Oops Re: Performax 22-44 problem

galen V

>What do they say about assuming something.

I assumed Performax 22-44 is the direct drive Pro not a belt driven.

I assumed drum was run without feed and conveyer was run to see independant if either produces noise. You did say it was while sanding, so under load. Noise may not be apperant under no load but should have ask.

I assumed monthly maintenance done per manual like conveyer tension/tracking, convyer bushing lubrication and set screws on bearings and coupling all done.

Smarter man may be at the service center that would ask what I did not.