Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Grinding wheel runout *LINK*

Posts

Grinding wheel runout *LINK*

#1

Grinding wheel runout *LINK*

Dan Mitchell

>Bought a Woodcraft 8� low speed bench grinder for sharpening purposes. Comes with 60 & 120 grit white/friable wheels. 1st thing I notice is the right (fine) wheel has what seems like quite a bit of edge runout (wobble) on the broad side face of the wheel, about 3/64� from the look of it. Tried taking the wheel off & checking the arbor, the arbor seems true. Remounting/retightening the wheel made no difference. Since the wheel is not thinner at the low spot, this means the grinding surface is also oscillating back and forth by the same amount. It�s as though the wheel has a slight �bow� in it, or (more likely) the center hole is not 90 degrees to the face. Laying the wheel on the cast TS tops seems to indicate it�s flat enough, so I�m guessing it�s the hole which is off. Is this an acceptable amount of runout, and will it cause any difficulties during sharpening? The coarse wheel is much flatter.

Thanks

Dan


http://www.woodcraft.com/family.aspx?familyid=4605

Re: Grinding wheel runout *LINK*

#2

JL

Re: Grinding wheel runout

JL

>Some thoughts.

1) If you flatten the wheel - will there be any runout? I mean the first time you take a dressing tool to the wheel, it will effectively take out any concentric deviations. I don't ever use the side of my grinding wheel (except my Tormek).

2) Why bother leaving the stone on the grinder? Personally, I'd rather have a nice Norton. They are much better wheels.

Re: Grinding wheel runout *LINK*

#3

Re: Grinding wheel runout

galen V

>The washers backing the stone may not be flat and making the stone wobble. I assume for the price they are stamped metal not a heavy plate washers. Lay them of a flat surface to check. In an earlier post I noted I had similar problem with Norton wheel. The fix on it was the plastic center step bushings were not true. In my case I had old busings and they made it run true. Dressing the surface will give you "flat" surface and the slight side to side, well, you move your tool that way anyway across the face.

Re: Grinding wheel runout *LINK*

#4

Re: Grinding wheel runout

Claire

>I purchased the same grinder this Spring. When I set it up I had the same problem you are desribing with the course wheel.

A quick call to Woodcraft and then one to the grinder manufacturer resulted in a new wheel being delivered to my house in 3 days time. They never even asked for the old one back.

I have since set up the grinder with the Wolverine jig and love it. If I had to do it again I would wire in a light to the grinder switch.


img

Re: Grinding wheel runout *LINK*

#5

Re: Grinding wheel runout

Dan Mitchell

>Thanks for the replies on this, maybe I'll try giving them a call.

Though I'm pretty cynical, having had a similar experience with the warped fence of a Delta jointer a few years back. The replacement was actually worse then the original.

Dan

Re: Grinding wheel runout *LINK*

#6

Even the best wheels are rarely perfect *LINK*

David Barnett - SW Florida

>In my experience, no wheel, even Norton (which I prefer) is perfect. As long as there are no serious shaft or bearing issues with the grinder, you could compensate for wheel inconsistencies by balancing them. I've used the earlier version of OneWay balancers for over a decade with superb results on my slow-speed Baldor and highly recommend them.


One good place to get 'em