Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

favorite new tool

Posts

favorite new tool

#1

favorite new tool

janderr

>I build some high end dining tables and noticed on my last glue up that the top had deflected. a bow of about 1/4" over 96". well my glue up table, a torsion box, had the same deflection so I wrecked it.

My new table has 1/4" X 2 1/2" steel flat bar inlaid into the 2X6 jointed side rails wich cost me about thirty bucks. let's see if this one deflects.

Re: favorite new tool

#2

I wouldn't mind seeing some pics ;-)

Dan Mitchell

>

Re: favorite new tool

#3

question

Bill Tindall, E.TN

>Why is a bow of 1/4" in 8' a problem? I can not imagine any typical table structure so rigid that an 8' span would not conform to the vagaries of the floor it sits upon.

Re: favorite new tool

#4

Skirt?

Alexander Grigoriev

>Would not skirt board straighten it?

Re: favorite new tool

#5

David Marks . . .

steve mackay

>I saw the show with Mr. Marks doing this whole thing with the torsion box but admit I really did'nt "get" the whole thing. His looked pretty elaborate. Might you post some pics with "layman's" terms ?

Re: favorite new tool

#6

Re: Skirt?

Kneale Brownson dreaming of snow in N. MI

>I had similar thoughts to Bill and Alexander until I reread the original message: It's his glue-up table that he trashed after discovering it was the source of the bow in his product table top. The torsion box was supposed to keep the glue-up surface flat and didn't so he came up with the reinforced solution. He wasn't trying to fix the product table top, but rather his work surface.

Re: favorite new tool

#7

Re: David Marks . . .

Fred Davis

>Take a look at a Plano glue press . wall mounted , sticks out about four inches and you get a flat glue up every time.

FredD

Re: favorite new tool

#8

Re: question

janderr

>I use camberred cauls to keep the boards flat during glue up which I constructed using six laminations of 1/2" baltic birch. So at 3"X3"X5' these cauls are heavy. Add the clamps to that mix and I forgot to release before heading home for the night; so I had a lot of weight over too much time pulling down onto a sagged assembly table.

I did flip the glue up over onto my new flat table and piled weight onto the middle for a week and I think I may be OK. I will find out today after I cut in and apply my dovetailed aprons.