Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Urethane Glue on Chair Legs

Posts

Urethane Glue on Chair Legs

#1

Urethane Glue on Chair Legs

Paul Leuba

>I have inherited an attractive antique side chair from my mother and have just discovered that one leg is broken just at the point where it supports the seat. In order to do a proper job of repairing the undercarraige of the chair, I believe I should remove all 4 legs and disassemble the connecting spindles. Then, after turning a replacement for the broken leg, I should clean, glue and reset the leg assembly as a unit.

This seems to me to be the ideal approach, however, the leg assembly must have been previously repaired because there is a considerable amount of excess glue that has bubbled out around the 4 leg sockets. Although I've never used urethane glue, from other postings I've read on WC, I suspect that it was used on a previous repair job on this chair.

Is there a recommended approach to disassembling this chair undercarraige in consideration of the possible use of urethane glue?

Paul in Hunt Valley, MD

Re: Urethane Glue on Chair Legs

#2

JL

Re: Urethane Glue on Chair Legs

JL

>If you are trying to remove the urethane glue, good luck. Methylene chloride containing paint strippers can sometimes soften it enough to scrape it away - but they will also do a number on your finish.

My usual glue solvents are:

dilute acetic acid (high strength vinegar) for dissolving yellow glue.

steam and water for dissolving hide glue.

methylene chloride for softening polyurethane (somewhat dilute nitric acid will chew up polyurethane - and really do a number on your fingers, etc. - not to mention staining the wood and your fingers).

Epoxy - good luck, can sometimes be softened with solvents.

Cyanoacrylates - can sometimes be softened or dissolved with acetone-chilling will also affect the glue.

I'm not sure of the glue used in hot glue guns - I've never worked with them.

Re: Urethane Glue on Chair Legs

#3

Re: Urethane Glue on Chair Legs

Paul Leuba

>Thanks for the feedback, JL. These tenons are glued pretty deeply into the seat. I am not encouraged by the options to unglue them.

Paul in Hunt Valley

Re: Urethane Glue on Chair Legs

#4

Re: Urethane Glue on Chair Legs

Joseph Mulherin, Sr

>Paul, cut the legs off even with the bottom surface of the seat, then drill out for dowels both in the seat bottom and the legs.