Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Bed project

Posts

Bed project

#1

Bed project

Thomas S Stockton

>Just finished the woodworking on this bed and it is ready for finish. The material is walnut burl and walnut vener. The only solid stock is the front feet and headboard legs.

Tom


img

Re: Bed project

#4

Love the foot board

Bill Tindall, E.TN

>The development of the patterns in the foot is exceptionally attractive.

What is under the curved corner (ie how is the substrate curved)?

Re: Bed project

#5

Re: Bed project

Dick Coers

>Very, very nice work Thomas. Beautiful veneer!

Would you mind discussing your design decision to mix two different arch styles between the headboard and footboard? No criticism, just would like to hear your thoughts.

Re: Bed project

#6

Re: Bed project

Chuck in ND

>Nice job. Now here comes the fun part, bringing it to life with a finish.

Re: Bed project

#7

Alan Young

Great design work Tom

Alan Young

>Has the feel of a John Belter piece sans carving....You said the only lumber were in the footboard feet and the headboard legs- what about the side rails?

This is going to be spectacular when that finish hits.

Alan

Re: Bed project

#8

JL

Re: Bed project

JL

>I love the burl and the design. I didn't really notice any slat supports. Are there any?

Re: Bed project

#9

Re: Great design work Tom

Thomas S Stockton

>Hi Alan

Yea a little Belter along with some Biedimeir(sp) I think. The side rails are also veneered to keep the grain consistant and finding nice walnut these days is pretty hard.

Tom

Re: Bed project

#10

Re: Bed project

Thomas S Stockton

>JL,

no slats in the picture but there will be some along with a center support since the mattress set uses a pair of box springs.

Tom

Re: Bed project

#11

Re: Bed project

Thomas S Stockton

>Dick,

This project started out with a gallery sending me some pretty rough design ideas and a couple of pictures of what the client wanted. He really liked the idea of the footboard wrapping or flowing into the side rails and some of the original ideas I had had the headboard doing the same thing. I think if I had used the same curves for both it would have looked much to symetrical and the headboard ends in a different leg so I felt like it needed a different shape. If you look at beds it is pretty common to have differnt shapes for the footboard and headboard although it is usually a fancier headboard and the footboard is of a simpler design.

So the bottom line is I really don't know why they are different, it is what I thought looked good at that moment and the client who had been looking for a bed for about a year really liked it

Tom

Re: Bed project

#12

Alan Young

Curved Foot-Corner Panels

Alan Young

>I think I see the form used for the curved foot panels. How did you get the sides of these panels cut at 90 degrees to each other so they'd join the footboard and side board?

Alan

Re: Bed project

#13

JL

Re: Thanks

JL

>

Re: Bed project

#14

Re: Curved Foot-Corner Panels

Thomas S Stockton

>Alan

someone asked about the core and it is 1/4" bending luan. To cut the curves I made a jig that held the corner and ripped it on the tablesaw I then flipped the piece over and ripped the otherside. Since the piece was over length I just screwed it to the jig. The jig wasn't fancy and only took a few minutes to build. here's a very similar jig from a different project

Tom


img

Re: Bed project

#15

Re: Bed project

Jennifer@Indy.USA

>Tom, this is gorgeous. Just lovely. Thanks for sharing it.

Jen