Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Signature Medallions

Posts

Signature Medallions

#1

Signature Medallions

Gonzalo

>I was wondering if anyone had a good source for metal signature medallions. I am looking for 1" to 1 1/2 inch medallions that I can personalize with my name to discreetly put on furniture instead of using a branding iron, pen or burning tool. I have located several sources online, but they have minimums of 100 and require paying for the die, etc. Thanks in advance for any suggestions!

Re: Signature Medallions

#2

Re: Signature Medallions

howard

>You can get them at Rockler and Woodcraft at much smaller quantities, like 10.

Re: Signature Medallions

#3

Re: Signature Medallions

steve mackay

>Shy about plugging another woodworking site ( please forgive me for straying for a short time ) but theres a couple that make them over at Family Woodworking. I belive they can make them out of a couple materials. Not sure of the minimum order though. They're a "small" business. I'm into that.

Re: Signature Medallions

#4

Re: Signature Medallions

gonzalo

>Howard,

I tried both places and was told they did not carry them. The closest I have come is highland hardware in atlanta, but they have medallions made out of 3 ply. I was really looking for something out of metal, the ones I have seen look much better.

Re: Signature Medallions

#5

Re: Signature Medallions

Roger Lance in GR, Michigan

>there is a source that advertise in Fine Woodworking magazine...their ad appears in the last few pages of the magazine...I believe it is www.makersmarks.co.uk...good luck...a search under makers marks should bring them up.

Re: Signature Medallions

#6

How to make your own

Ken Platt (Granby, CT)

>This isn't exactly what you were asking, but there was an article in Wood magazine about making your own. They used copper sheeting, and a mask then etching. I remember it looked pretty neat, and not all that much work. I couldn't find it in a quick search of their index, but perhaps someone over at their site could help you.

The other possibility would be to try some of the laser-etching folks. Perhaps the same laser could do metal if you supplied the metal disks?

Ken