Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

OT: Soldering ball valve

Posts

OT: Soldering ball valve

#1

OT: Soldering ball valve

Bill Howatt

>Hi,

I have a new 3/4" ball valve to use as a water shutoff.

There is no mention about taking any precautions with soldering the valve to the lines. I am a bit concerned about what appears to be plastic surrounding the ball.

Is it necessary to disassemble the valve or just keep heat to a minimum?

Thanks,

Bill

Re: OT: Soldering ball valve

#2

Take out the ball!

Lee Schierer - McKean, PA

>I would if it were mine. It is a good idea to remove the ball and seals if you can. You can wrap a wet rag around the valve to protect the seals from heat, but it may also prevent you from getting a good joint.

Lee

Re: OT: Soldering ball valve

#3

Re: OT: Soldering ball valve

howard

>Just be sure the valve is left open so the heat dissipates into the pipe. You'll be putting the flame on the pipe, not the valve, so you'll be ok. Keep the valve open until everything has cooled down, then close it and turn the water back on.

Re: OT: Soldering ball valve

#4

Re: OT: Soldering ball valve

Rob Stokes in North Vancouver

>Most ball valves have a nylon (or other plastic) seat. This obviously is at risk if high heat's involved.

If you can take the valve apart, take it apart. If you have to leave it together, use MAP gas instead of propane as it will allow the area to be soldered to heat up quicker than if you used propane, and this will result in less heat transfer to the core of the valve.

When you've done one side, cool the whole thing with a wet rag and repeat on the other side.

Rob

Re: OT: Soldering ball valve

#5

Re: OT: Soldering ball valve

Howard Norman

>I have done a fair number of ball valves over the years. I have always had the valves in the open position while soldering. I have never had a problem with a valve.

Re: OT: Soldering ball valve

#6

Re: OT: Soldering ball valve

galen V

>Solved my problem dealing with heat on soldering valves. I pay a little more and buy compression ends. No worry about draining line back to prevnet creating steam, heat damaged ball or seats or finding a poor solder joint after the pressure is turned back on.

But then some are better at solder joints then I am since I do once in a great while.

Re: OT: Soldering ball valve

#7

Re: OT: Soldering ball valve

Justin Szeliga

>The plastic material the ball is surrounded by seems to be a bit more tolerant of heat than other seated valves. This is one time where you can heat the pipe instead of the fitting, & when the solder melts to the pipe, heat the valve keeping the flame perpendicular to the flow & on the fitting area. MAPP gas was mentioned & makes life a lot easier.

Peace

Justin

Re: OT: Soldering ball valve

#8

Re: OT: It's teflon

pecker

>The ball is teflon. It won't burn. It may swell a bit during soldering, but will return to it's original dimension when it cools.