Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Sand in ?

Posts

Sand in ?

#1

Sand in ?

Vincent Booth

>I was recently reading an article on applying finishes in which one is instructed to "Sand in" an oil based finish.

Does this mean to us sand paper to work the finish into the wood while it is still wet? It is not made clear in the article. Which I can't find now anyway.

Re: Sand in ?

#2

Ellis Walentine

Instant filler

Ellis Walentine

>Sometimes wipe-on/wipe-off finishes like long oils and "Danish" oils, which are never left to dry as a film but rather be wiped off, are "wet-sanded" with "wet-dry" paper, usually in the 320 - 600 grit range. This produces very fine sanding dust mixed with finish, which gets rubbed into any open pores in the surface of the wood, thereby filling and smoothing at the same time. Before this mess gets too sticky, you need to wipe/polish it off.

Ellis Walentine, Host

Re: Sand in ?

#3

Re: Sand in ?

howard

>what that refers to is when appying a penetrating oil finish, like tung oil, to open pore woods, when the surface is sanded when it is wet with finish a slurry is created that partially fills the pores which creates a smoother surface.

Re: Sand in ?

#4

Re: Instant filler

Bruce, a MN Galoot

>Ellis says: "Before this mess gets too sticky, you need to wipe/polish it off."

And if it does get too sticky while you're sanding it, just add a little bit more fresh finish and wipe it off. The new will thin the old and facilitate the process.

Bruce

Re: Sand in ?

#5

Good to know

Vincent Booth

>Thanks guys. That sounds very usfull, I'll have to give it a try on my next project.

Re: Sand in ?

#6

Re: Instant filler

Vincent Booth

>< Ellis > Sometimes wipe-on/wipe-off finishes like long oils and "Danish" oils, which are never left to dry as a film but rather be wiped off, are "wet-sanded" with "wet-dry" paper, usually in the 320 - 600 grit range. This produces very fine sanding dust mixed with finish, which gets rubbed into any open pores in the surface of the wood, thereby filling and smoothing at the same time. Before this mess gets too sticky, you need to wipe/polish it off. <

So, can you then apply a dry on film finish, such as poly?

If so, how long should I wait before doing so?

Re: Sand in ?

#7

Re: Instant filler

Fred Davis

>My cans of Watco Danish oil say to let dry 72 hours before applying a finish over them.

FredD

Re: Sand in ?

#8

Re: Instant filler

Vincent Booth

>Thanks Fred.

V.

Re: Sand in ?

#9

Re: Sand in ?

jan derr

>i use wet and dry paper to sand some surfaces up to 2000 grit which may be a bit over done but my folks like it. wet and dry works best with a lubricant and the first, very thinned coat of finish, will provide thet lubricant and also fill pores if necessary.

i can get a mirror on a table surface on a first coat of linseed oil thinned to four parts turpentine gritting up to rottenstone. The rest is earth paint mountain.