Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Reviving dead batteries *LINK*

Posts

Reviving dead batteries *LINK*

#1

Reviving dead batteries *LINK*

Tom Dunlap

>Does this Instructable make sense?

I have 7 dead 18v DWs and I was just going to send them if for rebuild from MTO.

Instead of arcing directly to the battery tabs I plan on taking a bad charger and use the base receiver with some wire leads to strike the arc. this should reduce/eliminate the arc scars on the good battery.

Also, stopping the wirefeed drive will eliminate the mess of the long wire hanging out.

The Instructables site has some good ideas. Some are whacked out...too many variations on spud guns/launchers and multiple ways to make LED flashlights or disquises for flash drives. Once a week I get an email about some of the additions. There have been several Instructables that have worked for me.


Reviving dead batteries

Re: Reviving dead batteries *LINK*

#2

Why use a welder?

Tim Greif - West of Chicago

>Grant in Iowa posted a while back about a trick to revive old batteries that would not take a charge due to discharge to absolutely zero (or nearly so) voltage. When that happens, most chargers won't recognize the battery.

I had the same problem with an old Ryobi 14.4V battery. Simply touch the leads from a 12 volt power supply to the battery tabs for a short few seconds. I'd imagine you could also use a battery charger or even you car battery for this. This gives it enough of a shot that the charger will again recognize it as a valid battery. Worked for me just fine.

Re: Reviving dead batteries *LINK*

#3

Re: Why use a welder?

Tom Dunlap

>After reading the replies to the Instructable I gathered that a higher voltage than the battery is needed. Someone showed that ganging together some 9v batteries would do the same. The welder is shown in the video to give 30v.

Re: Reviving dead batteries *LINK*

#4

Re: Reviving dead batteries

John K Jordan

>Tom,

We have fixed nicad batteries this way, using the discharge from a bank of capacitors. What happens is the chemestry in nicad batteres can cause crystals or "whiskers" to grow causing internal shorting. The high current discharge vaporizes the shorted area(s). Note that this method may or may not work depending on the severity and actual problem with the cell. Note also that for best results you should take the battery packs apart and only treat the individual cells that have problems, often only one in a pack.

Another thing to do is pick out the good cells in all of your battery packs and assemble them into useful battery packs. The hardest thing about this (assuming your battery packs can be opened with screws) is making the connections between the cells since they are usually spot welded at the factory. A battery store can replace all the cells and assemble them properly.

JKJ

Re: Reviving dead batteries *LINK*

#5

Re: Reviving dead batteries

iew

>Have any of you tried this? Looks scary. Looks too easy to be true.

Re: Reviving dead batteries *LINK*

#6

The report is coming

Tom Dunlap

>I'm charging my four dead batteries now. When I get to my shop I'll test my 12v car battery charger to see how many volts I get out of the 'fast charge' setting.

It seems a bit safer to use the battery charge than my welder. When I do the reviving I am going to suit up for welding, leather jacket, gloves and helmet. The jumping will be out in the driveway incase something tragic happens.

I'll report when I get done.