Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

OT: Replacement car battery cap

Posts

OT: Replacement car battery cap

#1

OT: Replacement car battery cap

Dan Mitchell

>So I went to check the oil in my wife's 2006 Impreza wagon, glance over & see one of the battery caps is missing. I figure I must have left it off the last time I added water to the battery, though of course I don't remember doing so. Looked around the general area of the battery, pulled the battery & tray, even got underneath & removed some of the shrouding, no cap to be found. Called the dealer, as I expected, no, they don't carry/can't order replacement battery caps. Before I plunk down 90 some bucks on a replacement battery, I'm wondering if anyone has any ideas on a cheaper solution. Of course, the caps are vented to allow gas to escape, so simply pounding in a cork won't do ;-)

TIA

Dan

Re: OT: Replacement car battery cap

#2

Re: OT: Replacement car battery cap

Howard Norman

>Interesting problem. I wonder if perhaps someone in the area that sells batteries might have a suitable replacement from a junk battery.

Re: OT: Replacement car battery cap

#3

Try local auto wreckers

Bill Howatt

>

Re: OT: Replacement car battery cap

#4

Re: OT: Replacement car battery cap

Dan Mitchell

>I wouldn't be surprised if someone in the battery business doesn't have one laying around, although on the battery retail side, the car being only 2 years old, it's unlikely they've taken in many cores of this particular model Panasonic battery. I have a 2003 Mitsubishi, checked to see if a cap from it would fit, same size, different thread. I figured junking a perfectly good 5 YO battery made more sense than junking a perfectly good 2 YO battery, but no dice.

Having spent a fair amount of time crawling around junk yards in my younger days, I can just imagine the reception I'd get if I walked in looking for a used battery cap... ;-)

Thanks for the replies.

Dan

Re: OT: Replacement car battery cap

#5

Re: OT: Replacement car battery cap

Kneale Brownson dreaming of snow in N. MI

>Take the little red plastic straw off an aerosol can, find a drill bit of its size, drill a hole in your cork, epoxy the straw into the cork and plug up your battery.

Re: OT: Replacement car battery cap

#6

Re: OT: Replacement car battery cap

Dan Mitchell

>Thanks for the replies. I took one of the remaining caps apart (they snap together), there's actually a fairly elaborate baffle system inside, to allow gas to escape, but not the electrolyte, which as I'm sure everyone here knows, contains sulfuric acid. At the moment, I have the hole covered with a piece of "Gorilla tape" a type of duct tape made by Gorilla glue that's quite tough, with some pin holes punched in it. I'm afraid anything other than plastic (like cork) will be eaten away by the acid. I'll see if I can find a plastic plumbing bit arrangement that will properly cover the hole, while still allowing access for adding water. If something pretty decent doesn't materialize, I'll end up getting a battery.

If this were my car, I wouldn't be as concerned, but I don't want my wife to have trouble someplace as a result of this.

Dan

Re: OT: Replacement car battery cap

#7

Lee Gordon

Re: OT: Replacement car battery cap

Lee Gordon

>"If this were my car, I wouldn't be as concerned, but I don't want my wife to have trouble someplace as a result of this."

Then why not swap batteries with your wife?