Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

OT Working with plastic lumber????

Posts

OT Working with plastic lumber????

#1

OT Working with plastic lumber????

Barry Irby

>I am working on a house for my cousin. Going to replace the exterior trim with plastic lumber. She is ordering it form a local wholesaler and most of it is 1 x 6's 18 feet long. Putting this up as rakes and facia.

Anyone have experience with this? How did you fasten it? How many fasteners? What kind? Did you "putty" the nail/screw holes. Did you paint the material? What did you use for paint?

Re: OT Working with plastic lumber????

#2

Re: OT Working with plastic lumber????

Clint Searl, at the base of Haycock Mtn

>I trimmed my shop/studio completely with MiraTec, 1x3 thru 1x12 as appropriate. Buy it in the correct widths so so it's not necessary to rip it. I attached it with the twisty 2 1/2 inch Maze nails. Painted with Behr exterior semi. The only lookout is that the stuff gets a bit wiggly in the 16 foot lengths. No problems after 5 years.

Clint

Re: OT Working with plastic lumber????

#3

Re: OT Working with plastic lumber????

Dave Bair, Eaton Rapids, MI

>The stuff will expand and contract markedly with temperature changes, so joint tightly in the summer heat.

Re: OT Working with plastic lumber????

#4

Re: OT Working with plastic lumber????

steve mackay

>I'm probaly off base on the plastic "lumber" but I did just finnish trimming the outside of the shop with a vinyl trim. Kind of neat. The color is "all the way through" so I'll never need to paint it. Had to fill a couple meitered corners, but I used white caulk and it looks pretty good. Used finnishing nails so I didn't bother with filler. Cuts like wood with a hand saw but I'd bet it'll melt a bit with a power saw. Only issue I saw was, if you need to remove it the nail head pulls through the piece easily.

Re: OT Working with plastic lumber????

#5

Re: OT Working with plastic lumber - Azek

Kevin Mac Luskie

>I used Azek brand PVC board to trim my work shop and my house. I wanted white, so I didn't paint it. I attached with 2 1/2" galvanized 16ga nailgun. PVC board has to be "backed", it's not self supporting. I used 2x6 for all of my sub-facia. The Azek was nailed top and bottom about every 18-24" I think. I follow whatever the manufacturers instructions were on the website. I filled holes with white caulk. I let it hang down far enough past the bottom of the 2x6 (about 1") to cover the J channel for the vinyl soffit.

-Kevin

Re: OT Working with plastic lumber????

#6

Re: OT Working with plastic lumber - Azek

George Koch

>With Azak type material(PVC) there is a special glue to use on the joints and miters that essentially fuses the pieces together like PVC plumbing pipe. You can also sand down and shape with no need for painting, but make sure you finish with a grit fine enough to match the factory face. As mentioned it is very flexible and long lengths are best installed with two men. George