Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Domed Trunk, progress and questions

Posts

Domed Trunk, progress and questions

#1

Domed Trunk, progress and questions

Bill Tindall, E.TN

>I got the domed lid fit to its frame today and the secret compartments and till were done last week. Lid fitting was tedious but not as much as "bull nosing" the edges. I could plane the long grain edge with the molding plane shown. The end grain was done with the low angle spoke shave. I tried scraping the profile and found that oak end grain can not be scraped. With the hard and soft parts, scraping yielded a wash board. Remaining is to smooth the outside, turn the bun feet and install hinge.

What kind of hinge should I use? I was thinking a brass piano hinge from LV?

Also what kind of handle should I install for opening the lid? Something neat, but what?


img

Re: Domed Trunk, progress and questions

#2

Re: Domed Trunk, progress and questions

Fred Davis

>With the overhang on that nicely coopered lid , I wouldn't think you would need a handle that would detract from the barrel effect of the lid.

so what did you smooth the insdie of the lid with?

FredD

Re: Domed Trunk, progress and questions

#3

Re: Domed Trunk, progress and questions *LINK*

Kneale Brownson dreaming of snow in N. MI

>I agree with Fred about letting the overhang serve for opening. I've used LV's solid brass piano hinge in such projects (but not the nicely domed lid you have) and liked that. Bit pricey, but you're making an heirloom anyway. For such a heavy chest, I'd use some solid brass stop handles on the ends.


LV Lifting Handles

Re: Domed Trunk, progress and questions

#4

Re: Domed Trunk, progress and questions *LINK*

doug f, san clemente, ca

>Bill - It really looks like the lid edge would be the most fitting handle for your chest. It's looking quite spectacular, by the way.

I've used this end handle on several very heavy blanket chests and it's held up quite well.

What kind of finish are you thinking about?

Looking forward to seeing the finished product.

Doug


Chest handles from Rockler

Re: Domed Trunk, progress and questions

#5

Re: Domed Trunk, progress and questions

allen heath

>I go here>>>> www.vandykes.com for reproduction chest hardare, including hinges, catches, lockes, straps, etc. anytime a customer has me work on a chest. They have reproduction hardware for chests.

Re: Domed Trunk, progress and questions

#6

JL

Re: Why piano hinge?

JL

>Your trunk is very handsome.

Do you want to have an ornate hinge or a plain hinge? Would the right style of ornate hinge add something to your finished piece? Would the wrong style detract?

Do you have a lid stop planned? Would you want a lid stop incorporated into the hinge?

Just some questions.

Re: Domed Trunk, progress and questions

#7

lid smoothing

Bill Tindall, E.TN

>"so what did you smooth the inside of the lid with?"

This operation was explained in an earlier post. Step 1 was to saw additional flats on the top of the staves and hollow out the bottom, again with the table saw. These operations made it so that less than 1/32" was required to smooth the curve. The inside was scrapped and then sanded with a curved sanding block. The outside will be sanded with a curved sanding block. I tried planing the top but the quarter sawn "flakes" keep popping out.