Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

making picture frame moulding.

Posts

making picture frame moulding.

#1

making picture frame moulding.

Paul Waddle

>In making simple picture frame moulding,I have found it necessary to turn the pc over(not end for end)to cut the outside edge to stay with the grain. Fist cut the inside decorative edge,change bit and lower it to cut the inside rabbit. Switch to a round bit and turn pc over to cut the outside edge... Am I making things too complicated??? pw

Re: making picture frame moulding.

#2

Moses Yoder

Re: making picture frame moulding.

Moses Yoder

>I bought a picture that was framed in the craftsman era, probably beteen 1900-1920 when Stickley was going strong. The frame is a simple 3/4" wide flat frame with slightly eased edges, a rabbet cut into the inside edge for the glass and picture. I am making several dozen similar frames for a number of prints we have accumulated over the years with some figured walnut. They are pretty easy to mill and assemble.

Re: making picture frame moulding.

#3

Re: making picture frame moulding.

Paul Waddle

>Yeaha Moses,its kinda easy work on the router table,but my results vary directly proportional to the attention I pay to the grain. Finally figured out how to make the rabbit and inside decorative edge with the grain. Mark direction grain,rout the rabbit on the edge(use fence),turn pc back to left and run flat on table against fence. Its satisfying when results are good. I cut miters on table saw and then sweeten them with the guillotine cutter. pw