What's a reasonable price to pay for 10/4 cherry?
JL
>FAS, rough about 50 board feet.
Knowledge You Can Build On — Est. 1998
What's a reasonable price to pay for 10/4 cherry?
JL
>FAS, rough about 50 board feet.
Re: What's a reasonable price to pay for 10/4 cher
John K Jordan
>Air dried? The last I bought was $2.00 per board ft from a local sawmill (air dried for 3 years) but that was a few years ago.
JKJ
Re: What's a reasonable price to pay for 10/4 cher
Mark Mandell - Gone Round In Jersey
>In my area you'll pay between $4 and $7 a bf for good stuff.
Re: Kiln dried
JL
>It's well over 2 5/8" in rough state. The board is ~15" wide. I decided to buy it. It planed down to over 2 3/8" clean. It really hurt my feelings to have to rip it before I planed it (I used a friends 15" planer). There is 1 substantial knot on a 10' board that is 15" wide. Very little sapwood. So $6.15/board foot is probably a reasonable price (at least I hope it is :)).
I'd say so....
John in New Mexico
>But then when I get some out here, it has to come by train or truck. I bought some 10/4 cherry about 5 years ago from a big yard in Phoenix and paid around $6.50/bf and none of the available boards were as nice as yours sounds! But I was making chair legs, so super wide wouldn't have mattered to me anyhow.
I think going to the yard and buying wood is my favorite part of building anything, next to actually finishing it!
Here is my 10/4 cherry find...
Kris Lasure
>I bought this log back in April which is sawn into 10/4 slabs. The widest point is about 19". Overall it came out about $2 per BF.
With the unusual curved grain pattern, I'm still thinking about the best way to incorporate the grain with a design. Have a few ideas, but since it was sawn in April, I have a little bit time to figure out the design by the time it's dry.
I think you did OK on your price. Good cherry is going to run in that range.
kl
If I could buy wood that cheap....
John in New Mexico
>I'd be one of these guys with two or three barns full!
Re: Here is my 10/4 cherry find...
Miles
>In one of James Krenov's books (The Impractical Cabinetmaker) there is a very nice example of making a table top out of boards like that, with curved grain. Apparently Mr Krenov found the challenge of joining the curved boards together in the way he wanted to be a considerable one - so perhaps 'nearly impossible' for us mere mortals would be an appropriate description. Nevertheless it might provide you with food for thought. The descriptions he gives of the details involved in designing and making the table are very enlightening.
good luck with your cherry.
Miles