Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

dent in furniture

Posts

dent in furniture

#1

dent in furniture

John Hoffman

>Hey guys,

A guy at work bought an 18th century chest of drawers and when he got it home he noticed a dent in the side. The dent is approx 8 inches long and the width of the tip of a ball point pen.

Anyway, I was thinking that putting a damp cloth on the scratch and then a hot iron over the cloth might force the wood to absord moisture and recover?

Anyone have ideas on this please?

Thanks

John

Re: dent in furniture

#2

Re: dent in furniture

Al Goldstein

>John,

I've used this method on raw wood with a steam iron and it works well. I think I read someplace that it will also work when there is a finish on the wood, but it takes more time.

You might want to try this on a section of the piece that is hidden from direct view to see if any damage is caused by the steam. For example if the finish is oil based, the steam might raise the grain if the piece was not planed or not sanded fine enough.

Al

Re: dent in furniture

#3

Re: dent in furniture

allen heath

>I have done this in the past and with pretty good success...be carefurl when you do this, especially if the wood has finsih on it...if the steam does not work, I have also had to put tiney pinprick holes into the finish to allow the steam to enter...like i said be very careful doing this, it takes a bit of patience. also, be careful not to damage the finish with the steam.

Re: dent in furniture

#4

Whoa! Hold the steam!

Thomas Skaggs, Foothills of Mount Level

>It's an 18th century piece...dents happen over the centuries. Why fix it? I suggest that your friend consult with a local reputable restorer. It would not surprise me if the answer was to do nothing to maintain the piece's value. Tampering with the finish might be a mistake.

Tom

Re: dent in furniture

#5

Re: Whoa! Hold the steam!

allen heath

>ok...i guess i should be a little more specific....yes, be very careful when doing this, especially on a finish. i do not use the stem from the steam iron, i put a small drop of water directly onto the dent, then place a light cotton cloth over it, then the hot iron...usually just the tip of the iron to avoid putting heat where i do not want it.

Re: dent in furniture

#6

Agree to Think First...

howard

>Do you know if this is an antique? If so, whatever you do, you'll need to think about what it does to the pieces value. For some antiques the only thing you can do is clean and add additional shellac. The damage you describe sounds like a scratch and not a dent that would be steamed out, especially on a finished piece, let alone a possible antique. As 8" long scratch that would catch a finger nail would need to be filled with a matching color fill stick. That's the technical side, but the most important thing, in my view, is to determine the value of the piece first.

Re: dent in furniture

#7

Agree With Tommy

George@Colonel's Workshop-Havertown PA

>Good afternoon John,

Your friend may be well counseled to consult with a conservator before doing anything. the piece's value as an antique could be compromised at any time in the future. Why rush into something BAD right away? Think first.

George

Re: dent in furniture

#8

Re: dent in furniture

Chuck in ND

>First of all if it's not yours, don't touch it. I know your intentions maybe good, but it's not worth it. Also something that old isn't going to be perfect, there are times when things do need to be fixed, I doubt this is one of them.