Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Cyclone lid + trash can work great *LINK*

Posts

Cyclone lid + trash can work great *LINK*

#1

Cyclone lid + trash can work great *LINK*

North of the Border

>for collecting saw dust and large chips (from your turning, e.g.). I hooked up for the first time my 1 H.P. D.C. to my bandsaw (and later my tablesaw)via the cyclone lid and did some work. The suction from the can was strong and most of the dust (99% according to the spec.) was collected in the can. The can also provides some protection for my motor fan on the D.C. as large pieces, wood or otherwise, are not sucked into the D.C. directly.

There're several kinds of such lids in the market. Get the ones that make the inlet air swirl around. Mine was from LV. Worth the investment.


img

lid

Re: Cyclone lid + trash can work great *LINK*

#2

Re: Agree! Cyclone lid + trash can work great

Bob Entwisle in NJ

>Yes, and it's a WHOLE lot easier to just pull the collector lid off the trash can and empty that, than it is to fool around with the bags and clamp rings etc. on the collector!

Bob

Re: Cyclone lid + trash can work great *LINK*

#3

Hear hear

Clint Searl, at the base of Haycock Mtn

>

Re: Cyclone lid + trash can work great *LINK*

#4

Re: Cyclone lid + trash can work great

Dave Bair, Eaton Rapids, MI

>When I swapped the 5-micron bag on my JET 1100 for a cannister filter, I found I had to open four dust ports to keep from sucking all the chips out of my LV-lidded trash can. Once the filter got a little dirty, I could reduce it to two. But I have to remember to open four ports right after I clean the filter.

Re: Cyclone lid + trash can work great *LINK*

#5

Re: Cyclone lid + trash can work great

Pete LaBelle

>Cut a 1" wide slot in your trash can bout 4" from top & bottom, and with a couple dozen screws, attach a piece of clear Lexan to use as a sight glass. When mine gets near 2/3 to 3/4 full, more carryover goes into the dust bags. Keep it less than that, and I'll empty the trash can a couple dozen times before I have to tear apart the dust bags.

Re: Cyclone lid + trash can work great *LINK*

#6

Re: Cyclone lid + trash can work great

Chuck in ND

>Not a bad idea Pete, but I think you need to point out that when you install that window it needs to be sealed up air tight or you may lose some of the effectiveness of the cyclone.