Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Raised Panel Bits

Posts

Raised Panel Bits

#1

Raised Panel Bits

Tom Rex

>I�m looking to purchase my first set of raised panel bits.

I'm looking at the

Freud Quadra-Cut Bevel Raised Panel Bits with Backcutters

and the

Woodcraft Anti-Kickback Three Piece Panel Raising Router Bit Sets.

There is quite a difference in price.

The Freud bits are $99.99 a piece and the Woodcraft set is $124.99.

Are the Freud bits worth the difference?

Will I be satisfied with the Woodcraft bits?

Re: Raised Panel Bits

#2

Re: Raised Panel Bits

mike@american sycamore

>Buy the Freud! I sold WoodCraft bits.......they are sometimes very poor quality. I ruined an expensive counter top when the bearing failed on the brand new bit. I had only a few feet to do so I thought that I would save some cash and buy the WoodCraft one insteaad of good quality like the Freud or Whiteside. I ruined a days work and $125.00 worth of plastic lamenate! The most expensive cheap bit I ever bought!

Re: Raised Panel Bits

#3

Re: Raised Panel Bits

Frank Bergmaier

>I second Mike. You can't go wrong with Freud. I have a large number Freud blades and bits -- including a raised panel set -- because they simply outperform the rest. I have no connection to Freud or a retailer.

I think this is a case where you get what you pay for and in the end you will save in both time, money and quality of cut.

On your search for best price, check out www.routerbitworld.com. They have $1 ship and in my experience good service.

Frank

Re: Raised Panel Bits

#4

Re: Raised Panel Bits

Larry Clinton At Frankfort (Central)., Indiana

>I would go with the Freud. I have a full set of Freud panel cutter bits, (not the new Quadracut) and have made several doors/panels using them. The fit is great and they haven't shown any dulling as of yet. I currently only buy Whiteside. Gradually replacing all my older, off-brand (as I consider Rockler, Woodcraft MCS etc.) bits with them, but doubt I ever replace the Freud bits I own.

Re: Raised Panel Bits

#5

Just to be different

Ken Garlock, Collin County Texas

>Hi Tom.

A couple years ago I bought a pair of Rail and stile, and a raised panel bit from the people at Eagle America. The raised panel bit has the back-side cutter. All three bits do a great job. The raised panel bit will do the job in a SINGLE pass with the PC-7518 doing the driving at 12K rpm. I would buy them again from Eagle America without a second thought.

I learned last week that the Bits from Eagle America are repackaged Whiteside bits. They look just like a Whiteside package, only the label is different.

Happy sawdust,

Ken

Re: Raised Panel Bits

#6

Re: Raised Panel Bits

Bob Persing

>Tom,

I have a "set" of rail, stile, panel, and glue joint bits from Freud. It is an older set and does not include the back cutter. I have found them to be top notch. I raised panels in cherry stock with no burning (as cherry is sometimes know to do). I did use several passes when raising the panel with the last cut being ever so light. The rail and stile bits gave a perfect joint. I personally like the dedicated rail-stile bits as opposed to the combination bits.

Bottom line is that I have been very pleased with my Freud products and have found that Freud offers one of the best bangs for the buck when it comes to cutting edge tools.

BobP