Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Treated wood splinter question.

Posts

Treated wood splinter question.

#1

Treated wood splinter question.

Barry Irby

>A couple of weeks ago I got a splinter in the palm of my left hand. It was from treated wood decking called Micro Pro (I think). I thought I got all of it out, but now I am not sure. The cut has healed, but the area remains slightly inflamed and sore.

What now? I don't see any evidence there is still a splinter in there. It's in a crease in my palm. Could there be some of the chemical remaining? Any suggestions?

Re: Treated wood splinter question.

#2

Re: Treated wood splinter question.

Lee Schierer - McKean, PA

>In the past when I had splinters from treated wood, I noticed they quickly became inflamed. Usually, once the splinter was removed they would heal within a day or so. If your inflammation persists, it would be advisable to see a doctor.

Lee

Re: Treated wood splinter question.

#3

Amputation

Clint Searl, at the base of Haycock Mtn

>

Re: Treated wood splinter question.

#4

Barry

George@Colonel's Workshop-Havertown PA

>Good Afternoon Barry,

A couple years ago a small splinter drove itself into the outside knuckle of the third digit of my right middle finger. I was concentrating on my lathe and hardly noticed any pain at all. It healed over almost immediately. A couple weeks later the site was visably infected, but the ER mis-diagnosed it as pseudo-gout. The untreated splinter resulted in a systemic infection which compromised my kidneys, elevated my potassium level and depressed heart function. My heart rate was about 18 beats per minute when I got the shock treatment and dialysis in the ER. I'd have been pushing up daiseys had we waited another few minutes before 9-1-1. I would advise you not to fool around.

George

Re: Treated wood splinter question.

#5

Re: Treated wood splinter question.

Ken Platt (Granby, CT)

>My bet would be that there is still s small bit of wood in there. Wood (and most organic materials) provokes a pretty good inflammatory foreign body reaction, even if it isn't infected. The piece can be amazingly tiny. I don't know what chemicals might have been in the wood, but if you can find out I can look up whether any might be a problem in small amounts. Seems unlikely, though, since there couldn't be too much of anything in a splinter-size piece, and you'd have gotten most of that when you got out the bulk of the splinter.

2nd choice would be a low-grade infection. Sometimes the bugs aren't that mean, but our immune system can't quite nuke 'em, and you get this sort of ongoing low intensity thing.

What to do? Safest bet is to see somebody medical, but I hate going to the doc, so I tend to wait and see how things go. That doesn't always work out as well as one might hope, though, as George mentioned (scary story, that).

Ken

Re: Treated wood splinter question.

#6

splinter removal *LINK*

Ed Mulligan, Cape Cod

>On the subject of removing a splinter, I have a pair of tweezers with an attached magnifying glass that are invaluable for solo splinter removal.

I just looked around a bit on the web and did not find the exact tweezers I have but Lee Valley sells one similar.

With the magnifying glass it is possible to see tiny bits that might be left in the wound when the bigger splinter has been removed.

Ed


Tweezers

Re: Treated wood splinter question.

#7

Re: splinter removal

John K Jordan

>If at home I use a low power stereo microscope for the same thing - built-in light, good view. If it's deep, I usually make an incision with a scalpel or xacto knife - cleaner than the old way with the sewing needle.

If out, I find the swiss army knife works well - mine has a good magnifier, tweezers, and a sharp pin.

JKJ