Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

5 Degrees last board and

Posts

5 Degrees last board and

#1

5 Degrees last board and

Dustmaker Mike

>Well yesterday I was worknig on a few rotten spots around one window. I had the old brick molding off and was getting ready to cut a new one. I had already replaced the sill plate when I felt a few sprinkles so I hurried up and cut the miter and then went for the lenght. The sill was beveled about 5 degs so I cut the bottom of it at 5 degs. The rain started to come down pretty hard just as I put everything away.

So today I start to work on another piece of brick molding and had just over the 8" it needed. This piece was on the side of the front door so I really wanted a tight fit. I measured twice and made the cut, just as the saw finshed spinning down I relized I had left it on the 5 deg setting from the day before. The piece was now just two short and did not look right. So back I go to the Blue Borg 10 miles one way to get another piece of brick molding. I

What gets me is how bad two of my window sills are. I bought the house last year and the paint looked good but this year I was doing a better inspection and found three places that had been repaired before with wood putty it must have held the water in. The paint still looked good but a press of a finger nail told a different story. I have been bondoing where needed and caulking the rest. Gota love owning a house.

Re: 5 Degrees last board and

#2

Re: 5 Degrees last board and

Tony - Memphis

>Yeah, I spent a some time this weekend caulking some gaps and painting. I bet every piece of my trim has at least some rot in it. It upsets me that with a little bit of effort, this could be avoided. I have several places where the wood shrunk and opened a joint and water got in. I try to watch for that stuff and keep it from getting out of hand. I've wondered about using the pvc lumber like they have used on This Old House next time. The door frame around my shop was in pretty bad shape after a few seasons. I repaired it and have tried to keep the water off of it (storm door and awning). This house/shop is only 10 years old. Fortunately, its brick so there ain't much wood to rot! They did use PT around the garage. The paint was cracking off of that, but I cleaned it up and sealed the ends (that was tough getting my fingers under them). Now, the dormer over the garage....its in pretty bad shape. I may gave to replace the trim there in a year or two. Already had to replace wood on the chimney and bondo some major cracks. Yeah, I'm all too familiar with that ripply look of the surface where you just know its gonna cave in when you touch it!

Tony