Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

An adventure in Gilding

Posts

An adventure in Gilding

#1

Alan Young

An adventure in Gilding

Alan Young

>I am working on this writing desk. I have added some gilding to project using Sepp Mica Powders.


I started by gilding these applied carving pieces. I mixed the powder with Seal Coat and brushed it on.


I applied two coats letting the shellac base dry in between coats.

I was somewhat concerned that subsequent coats would dissolve the previous layer but I was please to find that these powers fill in quite readily. It is a matter of mixing the desired concentration. I have gone for a rather heavy mixture....

After playing around with the carvings I moved onto the legs. I taped off the areas that border the designated gilding segments-


I removed the tape and began applying a stain to the remaining areas. I am giving this a wash of a red mahogany stain.


I applied the stain with a small artists brush-being very careful to let the stain ease up to the gilded borders...I was happy to find out though that even if a good deal of stain washed over the gilded segments-the stain did not penetrate those areas. A paper towel or rag removed any stain on the gilded areas.


Here are the legs set into the case and the desk.


The glided drawer casing is glued in place. The other gilded carvings are taped on for now.


It's a challenge to gild enough but not too much in a busy piece like this. The top will have profile that closely follows the perimeter of the casework-in other words I plan on just enough overhang or lip to allow for wood movement. The top will have a a fairly "busy" profile routed along it's edge and that edge will receive a gilding as well.


Thanks for looking...

Alan

Re: An adventure in Gilding

#2

I do believe

Joanne Adler in Pt. Pleasant, PA

>that Mr. Darcy and Miss Bennett would most happily approve!

I certainly do! Nice work. Thanks for the gilding lesson. Doesn't look so daunting as I'd imagined.

Joanne, off to continue reading a modern novel, written in Austen's style, about the "next chapter" in Elizabeth and Darcy's life. Fun stuff for Austen fans.

Re: An adventure in Gilding

#3

Nice project, nice article, Alan.

Rod Peterson -- Ormond Beach

>It's 80% done toward being a WC Article.

Rod

Re: An adventure in Gilding

#4

You Are As Good As Gold, Allan!

George@Colonel's Workshop-Havertown PA

>

Re: An adventure in Gilding

#5

Alan Young

Dear Miss Joanne.....

Alan Young

>You are most kind. Thank you for your "Good Opinion" I shall endeavor not to lose it.Pray,do enjoy the book and send my best wishes to

Mr.D and Miss E....

Your must humble furniture raconteur.

Mr. Young of Ypsilanti Estate

Re: An adventure in Gilding

#6

Alan Young

Thanks Rod, It's been a fun adventure..

Alan Young

>Rod-let me know what the other 20% is ...Finished pictures?

I will probably forget to pursue the article :^)

Alan

Re: An adventure in Gilding

#7

Alan Young

Thanks George! ......

Alan Young

>That means a lot coming from the top Brass!

Hope the clock re-work is coming along well.

Alan

Re: An adventure in Gilding

#8

Re: Thanks Rod, It's been a fun adventure..

Rod Peterson -- Ormond Beach

>> Rod-let me know what the other 20% is …Finished pictures?

No, the pictures were great. It's backend coding—<alt> & <title> tags for the pictures and appropriate terms for the <meta> keywords tag.

> I will probably forget to pursue the article

Ha, ha. I'll let you know when it's up.

Rod