Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

sound proof insulation for basement

Posts

sound proof insulation for basement

#1

sound proof insulation for basement

Steve Silca

>I am trying to isolate my basement from the first floor in terms of sound, yet still maintain the "loft" feel. In other words, I don't want to jst attach drywall to the bottom of the floor joists - the reult would be a ceiling that is 7 ft. My idea is to attach a 2x4 to the the floor joists right up against the subfloor, put some insulation in between, and then but two layers of drywall up. This will be like a 4" pocket to deaden sound.

What do you think? More importantly, is there a speciic insulation that is beter for this application? thanks

Re: sound proof insulation for basement

#2

JL

Re: sound proof insulation for basement

JL

>Going to sound strange, but so be it.

Put some "blueboard" or insulating foam board between the 2x4 and the subfloor. This will lessen the sound transmission.

Re: sound proof insulation for basement

#3

Re: sound proof insulation for basement

Scott in Montana

>Hello Steve,

There are lots of things you can do to keep the noise or energy in your shop and out of other areas.

Leaving the joist spaces open is a good thing as it will trap and dissipate a share of the mid to lower noise spectrum. Inside these areas you should install a minimum of 3.5" of fiberglass acoustic insulation. You could use standard fiberglass thermal insulation but it will trap heat in your shop rather than letting the convection to occur and depending on the design of your heating system this could cook your shop and cause the room above to be chilly. Anyhow, if you desire to install a smooth surface below that to prevent dust accumulation, you could use sheetrock, rigid fiberglass, or rigid styrofoam insulation. If you use sheetrock or any other heavy material you will want to use drywall standoffs or "Z" track made to isolate the material from your joists or floor above.

The transducer of noise that many people miss is the bearing walls in their basements. Any wall with a load will vibrate like a violin string with tension on it; at a much lower frequency of course. This vibration will not only carry noise to your main floor but all the way up to the upstairs or attic. A general noise mitigation solution for these walls or posts is to sheetrock them using standoffs and two layers of 1/2" or 5/8" sheetrock with a layer of silicone squeezed in between or a layer of 1/4" sponge foam. This will deaden the low frequencies before they reach the bearing walls or posts. The silicone or sponge foam keep the two sheets from rattling and will also kill vibration due to being a dissimilar material. There are specific sheetrock materials used for specific frequencies, but the costs can be staggering.

Erratic shapes also help to dissipate noises. So if you have a long straight wall, break it up by hanging some things on it. (the perfect excuse to buy more tools and tell your wife that you are just trying to make her life more peaceful). The shapes break up sound waves in the air and the different weights load the wall erratically and break up the waves in the wall

And I guess finally, if you have the opportunity to frame a new wall for your shop, don't make it parallel to the others and this will help dissipate sound much quicker as well.

If you still have annoying noises after trying some of these fixes, you might borrow or rent a spectrum analyzer/sound pressure meter from a musical instrument or sound reinforcement store it would show you your exact problem frequencies and their amplitude. Once determined you can research the remedy from there.

I've written this quickly so I'm sure I've overlooked a few things, but this might get you started.

Good luck!

Scott

Re: sound proof insulation for basement

#4

Re: sound proof insulation for basement

Jay St. Peter - Southern, MD

>Putting the insulation in will help. But, since the vibrations will hit the joists and transmit right upstairs the effect will be limited. Unfortunately, the best way to control sound is to isolate it from the structure. Both insulation and some resilient channel on the joists with drywall attached will do what you want sound wise. But, it puts the drywall even another 1/2" lower.

Jay

Re: sound proof insulation for basement

#5

Re: sound proof insulation for basement

Scott in Montana

>Yup, Jay's right.

Something I overlooked in my haste was that that you could add various amounts of weight to the joists in order to make them resonate at different frequencies and therefore have a cancelling effect on each other when they connect to the floor.

You could use any heavy material (dare I say lead these days?!) and simply bolt and/or glue it to the joist. Assuming that your joists are not over 16 feet long, weighting them with between three to ten pounds should help. Make it random; nothing on one, eight pounds on the next, four pounds on the next, maybe three pounds on the next, and so fourth. Also you can spread the weight out along the joist, again keeping it random. I would keep it away from the last two feet on either end as it will start to lose its efficiency near the ends.

Again, hanging new tools from the joists will be to your wife's benefit! :O)

If you have the structured joists such as silent floor, knock out half the perferated utility holes. Again making everything radom. Energy hates working around random.

Scott

Re: sound proof insulation for basement

#6

Re: sound proof insulation for basement

Charley

>Attaching any flat ceiling directly to the bottom of the floor joists may deaden the sound of the high frequency noises some, but building a separate ceiling support that has no direct hard connection to the joists above will do the best to minimize the low frequency transmission. There are sound deadening products available such as vibration isolators that you can use to hang this lower ceiling support from the rafters above that will make a big difference in how much noise is passed on to the space above. Do a Google search for them. A sheetrocked ceiling on a 2x4 frame supported by these dampeners with lots of fiberglass insulation between this ceiling and the floor above will significantly reduce the sound transmission. Unfortunately, the only way to totally eliminate sound transmission is with about a 3' layer of concrete.

Charley

Re: sound proof insulation for basement

#7

Re: sound proof insulation for basement

John K Jordan

>I don't know if it would work between ceiling joists, but when my grand piano (7' Baldwin) nearly blasted me out of a small room, I cut blocks of 4" thick foam rubber and stuffed it into the frame just below the soundboard. It made an amazing difference in the volume and I've kept it that way for the last 30 years. (My piano tuner continues to kid me about this after all these years.)

JKJ

Re: sound proof insulation for basement

#8

Re: sound proof insulation for basement

Fred Davis

>Steve,

get in touch with a drywall contractor or acoustic spray applicator and get their opinion on the efficacy of spraying acoustic directly on the bottom of the upper floor and the joists.

This product has been around for years, it breaks up sound, absorbs sound and if you use the standard white , it will raise the light level in your shop.

Plus it is relatively inexpensive compared to engineered approaches to sound deadening.

FredD

Re: sound proof insulation for basement

#9

Re: sound proof insulation for basement *LINK*

albertabob

>I used Roxul R22 for my shop.

You can't hear anything with the door closed.

Bob


Roxul insulation

Re: sound proof insulation for basement

#10

Re: sound proof insulation for basement

Matt Ocel

>Scott has it right. Z channel or Resiliant channel is what we call it in MN. It improves your STC rating(sound transmission)

Re: sound proof insulation for basement

#11

Jim in Burlington Ont.

Sound deadening channel

Jim in Burlington On

>I'd put Roxul soundproof up. Use sound deadening channel to attach drywall to. There's no way to drown out the noise from a planer.

Re: sound proof insulation for basement

#12

Re: sound proof insulation for basement

Justin Szeliga

>I found a product a while ago called QuietRock. It uses a sound barrier laminated inbetween 2 sheets of rock. The literature claims much better, & tested, performance than sound channel. QuietRock.com.

Peace

Justin

Re: sound proof insulation for basement

#13

Re: sound proof insulation for basement *LINK*

Scott in Montana

>QuietRock is great material we specify and install it frequently. But, like many other things in this world, its performance is proportional to it price. QuietRock makes thicknesses all the way up to near 1 1/2 inches.

A link is below:

Scott


QuietRock