Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Staining from Titebond or Unibond?

Posts

Staining from Titebond or Unibond?

#1

Staining from Titebond or Unibond?

BobS

>I just picked up a couple pieces of my furniture from a clients house and noticed that areas of Maple and Holly veneer that were glued with Titebond 2 and Unibond have small spots of stain/mold under the finish. One was finished with lacquer, the other with conversion varnish. They were built months apart and from different batches of veneer from different sources. Anyone know what is happening? Is this going to get worse? It is not from the clients house.

Thanks

Bob

Re: Staining from Titebond or Unibond?

#2

Ellis Walentine

Re: Staining from Titebond or Unibond?

Ellis Walentine

>Hi Bob,

I missed this question a couple days ago and I thought I would try to

catch up with you and see if you had gotten any further information

about your staining/mold problem with the light-colored veneers. I am

assuming the veneer looked fine after spraying. If so, I'm thinking

there might have been some residual moisture in either the veneer or

substrate that was unable to get out once you applied a finish. I have

not had this problem with either type of glue you mentioned.

You might be able to bleach out the stain with either chlorine bleach or

oxalic acid solution. Try it on top of the finish first and if that

doesn't work in a day or two, sand or scrape the finish down to the bare

wood and try again. You'll have to repair the finish, which won't be too

difficult with the lacquer but will be tougher with the conversion

varnish. If the stains appeared a while ago and have not gotten worse,

you may be out of the woods, but you'll have to wait and see.

Sorry to hear of your predicament.

Ellis Walentine, Host

PS, your e-mail address is incorrect.

Re: Staining from Titebond or Unibond?

#3

Re: Staining from Titebond or Unibond?

BobS

>Ellis,

Thanks for info, I did try the Oxalic Acid, no effect so its coming from something else. I think I will reveneer the parts with another material and refinish them. Also, thanks for the note on the shop contest, I meant to reply to you but haven't had the time.

Bob