Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Liquid hide glue - slow to dry

Posts

Liquid hide glue - slow to dry

#1

Liquid hide glue - slow to dry

Joe in a Cleveland suburb

>Hi.

I am making a small Shaker table for my daughter. It's basically the one that was in the (I think) first issue of PWW's Woodworking magazine. I'm using walnut.

Yesterday I glued up the top. I used some liquid hide glue I've had for some time now. I put a drop between my fingers and pulled it apart a couple times. It seemed to be okay - got strings between my fingers and it was pretty sticky. I recalled reading that tip someplace to test if the glue was still good.

I did the glue up yesterday morning. In the evening I went to scrape off the excess with a dull razor blade before it got too hard. It was softer than I thought it should be.

This morning I checked it and it still seems a bit soft. It's not hard. I can indent it with my finger nail.

Is this normal? It's is a bit humid/rainy here. Does this affect hide glue's drying ability? Should I wait a day or two before I remove the clamps? Did I just make some more firewood?

Thanks.

Joe

Re: Liquid hide glue - slow to dry

#2

world expert on this adhesive......

Bill Tindall, E.TN

>lives over on the Hand Tool Forum. Ask there.

Re: Liquid hide glue - slow to dry

#3

JL

Re: Liquid hide glue - slow to dry *LINK*

JL

>There is a definite shelf life to liquid hide glue. I don't know how old yours is, but it may be too old.

The humidity can be a factor in slow drying and curing.

You haven't made firewood - after all, you can easily remove liquid (and solid) hide glue with hot water and steam.


Deller's article

Re: Liquid hide glue - slow to dry

#4

Thanks Bill and JL...

Joe in a Cleveland suburb

>I posted over there.

Re: Liquid hide glue - slow to dry

#5

Re: Liquid hide glue - slow to dry

Bill Tindall, E.TN

>Over on the other side you are looking for a response from S. Shepherd.

1. Test a joint with this glue. Glue up a test piece using a lap joint with. the ends of the two pieces sticking out. After a day, clamp one leg of the lap joint in a vise and bash the other leg sticking up sufficient force to break the joint apart. The wood should fail across most of the joint, certainly 75% or more. If it does not then the adhesive is inadequate for some reason.

2. The first time I used hide glue was to glue two 2 x4 cherry to make a 4" post that I then turned to make a cannon ball bed. The glue failed on some of the joints. I decided then and there that I was not going to use an adhesive that was inherently prone to failure if not "fresh" by some standard. I from then on used what the furniture factories use, yellow glue. You don't need to worry about whether it will work.

Re: Liquid hide glue - slow to dry

#6

Thanks Bill.

Joe in a Cleveland suburb

>