Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Changing the motor on a Performax Questions

Posts

Changing the motor on a Performax Questions

#1

Changing the motor on a Performax Questions

Barry Irby

>I have a 16/32 Performax. It has a 1 hp motor on it. Sometimes it could use a few more horses. I have a 2 hp motor that has the same

end mount on it I think. The problem is the new motor runs at 3450 RPM, double the speed of the original motor.

Would this work? Will the sand paper stay on the drum? Would it burn the wood worse? Where is Tim the Toolman when I need him?

Re: Changing the motor on a Performax Questions

#2

Re: Changing the motor on a Performax Questions

Ralph Turney

>I can smell the smoke from here, and what about the bearings. As they are, they spin pretty fast.

Re: Changing the motor on a Performax Questions

#3

Re: Changing the motor on a Performax Questions

Kneale Brownson dreaming of snow in N. MI

>Why not change the pulley on the motor to make the driven system revolve at the proper speed?

Re: Changing the motor on a Performax Questions

#4

Re: Changing the motor on a Performax Questions

Ralph Turney in Socal

>There is no pulley, it's direct drive.

Re: Changing the motor on a Performax Questions

#5

Stand back!!!!

Mark Goodall - ATL - tooljunkie

>... Oh, you meant the motor that drives the drum, not the conveyor belt ;) ;)

Happy Woodworking!

Re: Changing the motor on a Performax Questions

#6

Re: Changing the motor on a Performax Questions

Dick Coers

>My concern would be reduced life of the abrasive. You will build up more heat with more aggresive cutting, plus more pressure on the abrasive grain. Compared to a wide belt sander that has belts that are, maybe 6' long,the Performax abrasive comes around that little drum pretty often. I would say that you will use up the abrasive so fast that it may not save you any time in the long run.