Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Refinish old curved door *LINK*

Posts

Refinish old curved door *LINK*

#1

Refinish old curved door *LINK*

Harold Scott

>Hello from Portland Tennessee. My wife and I purched our first home in December and have come across a slight problem.

We have a curved top door, similar in shape of this door in the following link but not the same pattern. My door is a flat door with no molding but it does have three 6w x 9h windows in a stairstep pattern. Each window is missing the glass. The door was covered up by a piece of glued on pressed board. It is a solid wooden door with what appears to be a veneer covering on one side. This veneer siding is coming off thus my problem. How hard of a problem am I facing to have this door veneered and the windows replaced.

Are there any craftsmen or women in the Nashville area that would like to take a look at this job?


Curved door

Re: Refinish old curved door *LINK*

#2

JL

Re: Refinish old curved door

JL

>Does your door have a standard rectangular opening? It may be more cost effective to replace the entire door "assembly" rather than repair your door.

Another alternative is to make a new door to fit your opening. Repairing your peeling veneer and putting in new door windows may not be a one-day job. By the time you factor in the cost of gas....

Re: Refinish old curved door *LINK*

#3

Re: Refinish old curved door

Harold Scott

>The door fram is also curved. I have included a photo of the door after I have removed a layer of paneling that was glued to door. You can see the other sheet of paneling, throught the broken out windows, that I have not removed yet. It is hard to tell by the picture but the damaged veneer covering is just from the bottom middle of the middle window, two tears about 2" wide. The rest is just the glue and paint chipping. I would love to make a door if I had the materials, tools, and knowledge but alas I am not to that point.

We just purchased the house and I am just now starting to remodel an a old car garage into a shop.....and I have a LOOOOONG way on that project.


img